Connection of the gas hose to the oven, Caution, Pcirf – Инструкция по эксплуатации Beko CG 51010
Страница 27: Gas ieaicage coniroi
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Pcirf
Importani Insiallation and preparation at your oven
(^Before your appliance is
connected to the gas supply
check the ensure that the gas
category and pressure
specifications shown in the data
plate corresponds with your gas
supply. If necessary call
authorized service
for
adjusting to gas category.
^This
appliance
shall
be
installed in accordance with the
regulations in force and only
used in a well ventilated space.
Read the instructions before
installing or using this appliances.
In the interest of safety this
appliances must be installed
and/or serviced by a competent
person as stated in the gas safety
regulations current editions.
Please refer to the data plate
for details about gas supply and
pressures.
^ The appliance must not be
installed in a room without a
window or other controllable
opening. If is installed in a room
without a door which opens
directly
to
tohe
outside,
a
permanent opening is required.
The air circulation should be 2
m3/h per kW of burners.
Connection of the gas hose
to the oven
Convenient position is selected by
interchanging the hose nozzle and
plug according to the location of the
main gas inlet valve. If you make a
connection with a flexible metal hose
,
locate a seal between the main gas
pipe. The inner diameter of the flexible
hose, which the butane hose nozzle is
connected, should be 6mm for the
house-type gas tubes.
The inner diameter of the flexible hose,
which the natural hose nozzle is
connected, should be 15mm. The hose
should tightly be fitted to the hose
nozzle by squeezing with a clamp. The
plastic hose end is soaked in hot water
for one minute to soften and inserted
fully into the hose nozzle. The clamp
is fastened securely by a screw driver.
The other end of the hose is connected
to the gas valve with the same
operation.
The hose should be replaced before
its last expiry date.
Caution!
Make the oven connection to the
gas inlet valve, the hose length
must be short and be sure that
there is no leakage. The hose
used should not be longer than
125 cm for safety.
Connection of the gas hose
to the oven
Convenient position is selected by
interchanging the hose nozzle and
plug according to the location of
the main gas inlet valve. The plastic
hose end is soaked in hot water
for one minute to soften and
inserted fully into the hose nozzle.
The clamp is fastened securely by
a screw driver. The other end of
the hose is connected to the gas
valve with the same operation.
Gas ieaicage coniroi
During control, be sure that the
control knobs are closed and the
gas inlet valve is open. Apply soap
bubbles to the connections for
leakage control. In case leakage
exists, buble will appear. In such
case, check the gas connection
immediately. Do not control gas
leaks by using fire.
Caution!
Never use lighter or
match flame, for
controlling the gas
lockage.
Hose nozzle and
elbow types for
Natural gas and
Butane/propane