Beko CG 51010 - Инструкция (Страница 30)

Pott 4s Operating the top burners
I cm
^ 24 cm
To obtain maximum
etti€ien€y
A correct use to burner results
in gas saving and better out
put. Therefore we recommend
to use saucepans whose base
completely cover the flames.
Four saucepans with much
smaller diameters to be put
auxiliary burner, use the pan
support adaptor.
Flame failure
device
if your cooker has fíame
faiiure devise on gas burners/
In case of any flame failures
with any reasons in the top
burners, the flame failure
device immediately cuts of
the gas flow. It is also a safety
device for the wrong use of
the children.
You should turn the knob to the clockwise
direction by pressing. You should ignite by
pressing the knob and wait for its ignition.
You should keep the knob at pressed position
for 3-5 seconds after you see the flame
around the burner. Repeat the sequence of
operations if the flame does not continues.
6
Use of top gas burners
Turn the relevant knob by slightly pressing
in counter clockwise direction.
The large flame on the knob corresponds to
maximum capacity position and the small
flame corresponds to minimum capacity
position.
Ignition by button
(In models with ignition)
It provides automatic ignition.
When the button is pressed and released all plugs spark
at the same time. The ignition starts at the burner through
which the gas flows. If an ignition does not occur, repeat
the same action. Holding the button at pressed position
does not provide ignition.
In models vnlh IgnMon from Ihe knob
You should turn the knob to clockwise direction by
pressing. The spark occurs itself immediately on
the burners till you take your hand off the knobs.
After you release the knob, if the ignition does
not continue repeat the same process by keeping
the knob pressed for 15 seconds. If still no igniton
occurs, wait for 1 minute and repeat again.
Warning : Do not keep the knob in pressed
position more than 15 seconds.