Binatone Active XA1001 - Инструкция (Страница 9)

9
ENGLISH
LNR/P button [6] where the pause is needed (if a long pause is
necessary, then press the LNR/P button [6] several times). For example,
if you are dialing through a PBX and should dial '9' to access the PBX
trunk, press the LNR/P button [6] after entering '9' and then enter the
number you want to store.
Storing a number in the phone memory
You can store 16 phone numbers in the phone memory, of up to 20
digits each.
1. Press the MEM button [8], the indicator light [2] starts to flash.
2. Enter the number you want to store in the memory.
3. Press the MEM button [8] once again.
4. Enter a two-digit number (01 to 16) under which you want to store
the entered phone number.
5. After completing the above steps you will hear a beep and the
indicator light [2] will go out.
Dialing a number stored in the phone memory
1. Press the PHONE button [3], the indicator light [2] lights up.
2. Press the MEM button [8].
3. Enter the two-digit number (01 to 16) corresponding to the phone
number you want to dial
Note:
You can store in the phone number just a part of a phone number
(for example, the international telephone code) and combine memory
dialing with normal phone number dialing.
Deleting a number stored in the phone memory
1. Press the MEM button [8], the indicator light [2] starts to flash.
2. Press the MEM button [8] once again.
3. Enter the two-digit number (01 to 16) corresponding to the phone
number you want to delete.
4. After completing the above steps you will hear a beep and the
indicator light [2] will go out.
Changing the ringer tone
1. Press the VOLUME/RINGER / button [7] (the ringer tone
cannot be changed during a call), the indicator light [2] lights up.
2. To select the desired ringer tone, press one of the buttons 1…8 .
3. Press the VOLUME/RINGER /
button [7] once again, the
indicator light [2] goes out.
Changing the ringer volume
1. Press the VOLUME/RINGER / button [7] (the ringer vol-
ume cannot be changed during a call), the indicator light [2] lights
up.
2. Press the
∗
button to increase the ringer volume, press the # button
to decrease the ringer volume.
3. Press the VOLUME/RINGER / button [7] once again, the
indicator light [2] goes out.
Adjusting handset earpiece volume
During a call you can adjust the handset earpiece volume. To do
this, press the VOLUME/RINGER / button [7] during the
conversation.