Answering machine, 10 handset locator, Setting the clock – Инструкция по эксплуатации Binatone Active XA1001
Страница 10: Recording ‘outgoing message 1’ (ogm1), Recording ‘outgoing message 2’ (ogm2), Setting the answering mode
10
Handset locator
1. To locate the handset, it is necessary to press the PAGE ))) button
[18] and in so doing the handset will beep.
2. To cancel the handset locator function, press the PAGE ))) button
[18] once again or press the PHONE button [3] on the handset.
ANSWERING MACHINE
Setting the clock
1. Press the CLK
button [26] and hold it for no less than 2 seconds.
You will hear 'Sunday'.
2. Using the << [23] è >> [24] buttons select the correct day of the
week.
3. Press the CLK
button [26] again. You will hear ‘1 AM’
4. Using the << [23] è >> [24] buttons set the correct hour.
5. Press the CLK
button [26] again. You will hear ‘00'.
6. Using the << [23] è >> [24] buttons set the correct minute.
7. Press the CLK
button [26] once again. The answering machine
will say the day of the week and time you have set.
Note:
If you want to know the time, just press the CLK
button [26]. The
answering machine will say the day of the week and time. If you do not
set the clock yet, you will hear two beeps.
Recording ‘outgoing message 1’ (OGM1)
The OGM1 is used in the normal answering machine mode, when
the answering machine offers to leave a message. The standard pre-
recorded 'outgoing message 1' (OGM1) is as follows: “Please leave
your message after the tone”. You can record any other 'outgoing
message' with up to 60 seconds duration.
1. Press and hold the OGM1 button [25] until a short beep is heard.
2. After the beep say your message talking clearly as close to the
base unit microphone as possible.
3. To stop recording, press the STOP button [16]. Your new message
will be automatically played after the end of recording. If you want
to record a new message, repeat the above steps.
Recording ‘outgoing message 2’ (OGM2)
The OGM2 is used in the ’Answer only' mode, when the answer-
ing machine offers to call back later and the caller is not able to leave
a message for you. The standard pre-recorded 'outgoing message 2'
(OGM2) is as follows: “Please call later”. You can record any other
'outgoing message' with up to 15 seconds duration.
1. Press and hold the OGM2 button [12] until a short beep is heard.
2. Say your message talking clearly as close to the base unit
microphone as possible.
3. To stop recording, press the STOP button [16]. Your new message
will be automatically played after the end of recording. If you want
to record a new message, repeat the above steps.
Setting the answering mode
When setting the message on the answering machine you can select
one of two options: the normal answering machine mode (OGM1) and