Binatone Active XA1001 - Инструкция (Страница 13)

13
ENGLISH
2. Pressing the << [23] or >> [24] buttons, select the first digit of the
ID-code.
3. Press the ANS ON/OFF button [27] to confirm the selection.
4. Pressing the << [23] or >> [24] buttons, select the second digit of
the ID-code.
5. Press the ANS ON/OFF button [27] to confirm the selection.
6. Pressing the << [6] or >> [7] buttons, select the third digit of the ID-
code.
7. Press the ANS ON/OFF button [27] to confirm the selection.
8. Pressing the << [23] or >> [24] buttons, select the fourth digit of
the ID-code.
9. Press the ANS ON/OFF button [27] to finish the ID-code setting.
Checking messages
1. Calling your number from a touch-tone phone.
2. During the 'Outgoing message' (OGM) playback press the '*'
(asterisk) button twice.
The OGM playback will stop.
3. Enter your ID-code.
If you entered the correct code, you will hear two beeps, if not –
four beeps. If the code was wrong, you can re-enter it two more
times. If all three codes were wrong, the answering machine dis-
connects the call.
4. To listen to the messages, press '5'.
5. During messages playback:
Enter '99' to stop playback.
Enter '44' to repeat the current message playback.
Enter '55' to pause the playback; enter '5' to resume playback.
Enter '66' to listen to the next message.
Enter '77' to erase the current message.
Enter '88' to return to the first message.
6. Other actions that can be performed during remote operation
Enter '1' to listen to the 'outgoing message 1' (OGM1).
Enter '2' to listen to the 'outgoing message 2' (OGM2).
Enter '3' to turn the answering machine on/off.
Enter '*1' to record OGM1 (Press any button to stop recording;
the ‘outgoing message’ will automatically be played back.)
Enter '*2, to record OGM2 (Press any button to stop recording;
the ‘outgoing message’ will automatically be played back.)
Enter '*3' to enable or disable the ’Answer only’ mode. The
appropriate ‘outgoing message’ will automatically be played back
Enter '*4' to change the CBT code – enter the new code twice.
Enter '*5' to change the ID-code – enter the new code twice.
Enter '*6' to save all of your messages.
Enter '*7' to erase all of your messages.
Enter '*8' to listen to what is going on near your answering ma-
chine for 15 seconds. Enter '*8' to keep on listening.
Enter '*9' to disconnect.
Turning on your answering machine
1. Calling your number from a touch-tone phone.
The answering machine automatically answers after 8 rings, if there
are new messages in the memory, and after 10 rings, if new messages
have not been recorded. You will hear a long beep.
2. Enter your ID-code.