Binatone Active XA1001 - Инструкция (Страница 8)

8
Notes:
1. When you are not using the phone (for example, when you are not
at home), place the handset on the base unit so that the battery will
always be charged.
2. To ensure the maximum operating distance and noise-free
operation, install the base unit in a convenient location away from
electrical appliances such as a refrigerator, personal computer, TV
or another phone.
3. You can dial a phone number in the pulse or tone mode. To choose
the appropriate mode, just slide the P-T switch [38] to the “Tone”
position for tone dialing and to the “Pulse” position for pulse dialing.
The handset of the ACTIVE XA1001 phone will not operate in case
of a power failure. Therefore, for essential communications such as
medical emergencies you should have another phone that does not
requires an electric mains supply and will be operable in case of a
power failure.
If you are moving during a conversation and noise interferes with
the conversation, this may be caused by some interference, the source
of which is located between the handset and base unit, for example,
you may be too close to another phone or other electric equipment.
Move to another location as far from the interference source as possible
and press the CH button [10]. If you not do this, the call may be
disconnected.
MAKING CALLS
Making calls
1. Press the PHONE button [3], the indicator light [2] lights up.
2. Dial a phone number.
Answering calls
When the phone rings, press the PHONE button [3].
Note:
For noise-free conversation, it is necessary to extend the antennas
[11] and [29] on the handset and base unit.
Finishing calls
To finish a call, press the PHONE button [3], the indicator light [2]
will go out.
Redialing the last dialed number
1. Press the PHONE button [3], the indicator light [2] lights up.
2. Press the LNR/P button [6] and the last dialed number will be
automatically redialed. (You can redial a number consisting of no
more than 32 digits.)
Microphone mute
You can turn off the handset microphone during a conversation.
The calling party will not hear you.
1. Press the SEC button [4]. (When the microphone is turned off, the
indicator light [2] flashes and the handset buttons are locked.)
2. To cancel the microphone mute, press the SEC button [4] once again.
Inserting a pause in the dialed number
When saving a phone number in the phone memory, press the