Viewing product information, Checking the signal information, Upgrading the software – Инструкция по эксплуатации Samsung LE52A900G1F
Страница 41
english -
upgrading the Software
to keep your product up-to-date with new Digital television features then software
upgrades are periodically broadcast as part of the normal television signal.
It will automatically detect these signals and display the software upgrade banner. You
are given the option to install the upgrade.
1. Press the menu button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press the
enter button.
. Press the
▲ or ▼
button to select "Setup", then press the
enter button.
. Press the ▲ or ▼ button to select "System", then press the enter button.
. Press the ▲ or ▼ button to select "Software Upgrade", then press the enter button.
. Press the ▲ or ▼ button to select “Software Information”, “Manual Upgrade” or “Standby Mode
upgrade”.
Press the
enter button.
♦
Software Information
Press the
enter button, then the current software version is shown. To display the
software version information, press the
enter button again.
To switch to an alternative version, press the red button.
Press the blue button to reset, activate the upgrade and restart.
♦
manual upgrade
Press the
enter button to search for new software from the currently broadcasting
channels.
♦
Standby mode upgrade: on / off
Press the
enter button. To continue software upgrade with master power on,
Select On by pressing the ▲ or ▼ button. 45 minutes after entering standby mode, a
manual upgrade is automatically conducted. Since the power of the unit is turned on
internally, the screen may be on slightly for the LCD product. This phenomenon may
continue for more than 1 hour until the software upgrade is completed.
. Press the eXIt button to exit.
Checking the Signal Information
You can get information about the signal status.
1.
Press the
menu button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press the
enter button.
. Press the
▲ or ▼
button to select "Setup", then press the
enter button.
. Press the ▲ or ▼ button to select "System", then press the enter button.
. Press the ▲ or ▼ button to select "Signal Information", then press the enter button.
. Press the eXIt button to exit.
If the signal status is poor, the "No signal." message is displayed.
➣
Viewing Product Information
You can view your product information. For service or repair, please contact a
Samsung approved dealer.
1.
Press the
menu button to display the menu.
Press the ▲ or ▼ button to select "Digital Menu", then press the
enter button.
. Press the
▲ or ▼
button to select "Setup", then press the
enter button.
. Press the ▲ or ▼ button to select "System", then press the enter button.
. Press the enter button again, to select "Product Information".
The Product Information menu is selected.
- Software Version, Firmware Version
. Press the eXIt button to exit.
➣
Product Information
Software Version: t-PerlDeuC-00
Firmware Version: t-emmaDeub-010
return
DtV
move
enter
return
Signal Information
Service: ?
Service ID:0000
multiplex: ? (tSID 0000, onID 0000)
network: ? (ID 0000)
bit error level: 10
Signal Strength: 0
return
DtV
System
Product Information
Signal Information
Software upgrade
reset
move
enter
return
DtV
Software upgrade
Software Information
manual upgrade
Standby mode upgrade : on
move
enter
return
DtV
BN68-01625C-01Eng.indd 38
2008-08-19 �� 10:10:16