Troubleshooting – Инструкция по эксплуатации Elenberg DVDP-2420
Страница 58
58
Symptom
How To Check
The player can
not play.
• Make sure a disc is loaded.
• Make sure the disc is loaded with label side up.
• Disc should be clean, not dirty or warped.
• Player’s region code should be the same as the re-
gion code of the DVD disc.
• Make sure water condensation has not occurred? If it
has. remove the disc and keep the player power on
until the moisture evaporates.
There Is no
sound.
• Make sure the system connection is correct.
• Make sure the sound setup of DVD disc is correct.
• Is your disc dirty or warped? Clean or replace it.
• If wired headphones are plugged in, unplug them.
• If the audio cable Is plugged in, unplug it.
There is no pic-
ture.
• Make sure LCD or TV is turned on and in correct vid-
eo mode.
• Make sure your system connection is correct.
Poor AV perfor-
mance.
Is your disc dirty or warped?
Clean or replace it.
Can not contin-
ue to play and
play a section
repeatedly.
• Make sure the player is not in A-B repeat status.Press
A-B button to cancel A-B repeat status.
• Is your disc dirty or warped? Clean or replace it.
The remote
control does
not work.
• Make sure there is no obstruction between the re-
mote control and the player.
• Make sure you are pointing the remote control to-
wards the player.
• Make sure battery is inserted correctly (check polar-
ity).
• Replace weak battery.
Other possibilities:
Static or other external interfere may cause the abnormity of the
player. At this circumstance, unplug the power-supply cord from
the outlet and plug it in again to reset the player so that the nor-
mal operation will be resumed. If you are still having problems,
then please disconnect the power and consult your service center
or a qualified technician.
TROUBLESHOOTING