Dolby digital setup – Инструкция по эксплуатации Elenberg DVDP-2420
Страница 52
52
“ SPDIF Setup Page” and press [Enter] to enter the digital audio
setting page, and press ▲/▼ direction buttons to choose SPDIF
Output, CD, Dolby digital, MPEG, LPCM output and so on.
Select SPDIF Output
“Off”: the amplifier digital signal input off;
“RAW”: no decoding on the amplifier digital signal input;
“PCM”: the amplifier must be supported by PCM decoding or Dolby
digital decoding function.
“Manual” can self-choose Title’s output deploy.
Select CD
Under “SPDIF Output” status, and selecting “Manual”, in the “CD
disc” item, choose “SPDIF Off, SPDIF RAW, SPDIF/PCM”.
Select Dolby Digital
Under “SPDIF Output” status, and selecting “Manual”, in “Dolby
Digital” item, choose “SPDIF off, SPDIF RAW, SPDIF/PCM”.
Select MPEG
Under “SPDIF Output,” and selecting “Manual “, choose VCD item,
and selecting “SPDIF Off, SPDIF RAW,SPDIF/PCM”.
Select LPCM Output
Can select LPCM output with frequency out of 48K, 96K or 192k.
Dolby Digital Setup
Press ◀ to back to the audio setting page, in the audio setting
page menu, move ▲/▼ direction buttons to choose “ Dolby digital
setting”, press [Enter] to enter the
Dolby Setup page menu, and press
▲/▼ to choose Dual Mono, Dynamic
item.
Select Dual Mono
“Stereo”: stereo output signal;
“L-Mono”: left output signal;
“R-Mono”: right output signal;
“Mix-Mono”: left and right output
average signal.
Select Dynamic Compression
In “Dolby Digital Setup”, select “Dy-
namic” item, press “Play” to en-
ter the selection, move ▲/▼ to do
the setting, the compression ratio
greater, the less difference between
high sound and woof. This item is
only available to the Dolby sound
source.