45 load discs, Function operation – Инструкция по эксплуатации Elenberg DVDP-2420
Страница 45
45
Load Discs
After correctly connect the Player to other apparatus, turn on the play-
er and then follow below steps.
1. Turn on the player
Press the POWER button on front panel. then the player will search
for the disc automatically.
2. Press the EJECT button on the front panel or on the remote control
to open the disc tray.
3. Load the disc
Put the disc in the tray as shown in the right figure
4. Press the EJECT button to close the disc tray and begin playing.
NOTE: Please check the Disc condition before put it in the tray, bad
quality or damaged discs will damage the pickup inside the player,
and shorten its working time.
Function Operation Instruction
PLAY
Press the PLAY button to start playback. Press the POWER button
on remote control to enter standby status, and press it again to
resume playback status. If there is no operation for a long time,
the player will automatically enter screen saver status and then
enter standby status.
STOP
During playback, press the STOP button on remote control to stop
playback. For DVD discs, after pressing the STOP button once,
if you press the PLAY button, then the player will play from the
stopped point.
PAUSE
Press the PAUSE/STOP button on remote control to pause, and
press it repeatedly to achieve frame-by-frame playback.
REPEAT
1. Use the REPEAT button to repeat a title, a chapter, a track and a
disc respectively according to different discs, and also to cancel
repeat.
2. Use the A-B button to repeat section A to B. Press it once to set
the starting point A, twice to set the ending point B, and the third
time to cancel repeat.
NOTE: Some discs do not support repeat function.
VOLUME
During playback, press the VOL+ button to turn up press the VOL-
button to turn down.
FUNCTION OPERATION