Elenberg DVDP-2420 - Инструкция (Страница 41)

41
of the connected TV, set the “TV TYPE” to “16:9” in system setup
menu when wide screen TV connected, when connected to normal
TV, set the player’s TV TYPE to “4:3 PS” or “4:3 LB”.
S-Video connection setting
Connect the S-Video output jack on the DVD Player to the Display
device’s S-video input jack with a S-video cable. Under this mode,
there is no need to do the setting in the setup menu.
Y/Cb/Cr video connection setting
Connect the Y/Cb/Cr output jack on the DVD Player to the Display
device’s Y/Cb/Cr input jack with Y/Cb/Cr cable. Press [VIDEO]
button to shift the video output to YUV interlace signal output
mode. Shift the TV input mode to Y/Cb/Cr.
Y/Pb/Pr video connection setting
Connect the Y/Pb/Pr output jack on the DVD Player to the Display
device’s Y/Pb/Pr input jack with Y/Pb/Pr cable. Press the [VIDEO]
button to shift the Player’s video output to YUV Progressive signal
output. Then shift the TV input to the relevant mode. press the
[VIDEO] button, the screen will switch from interlace to progres-
sive output mode, repress the [VIDEO], It can work normally.
VGA connection setting
Connect the player to the display device with VGA cable if you
want VGA output mode. If the DVD Player’s video output is under
interlaced output mode, Select ‘VGA’ in the ‘COMPONENT’ menu,
press the Enter button, and restart the player, then the video out
is shifted to VGA output automatically.
If the DVD Player’s video output is under Y/Pb/Pr output mode,
Select ‘VGA’ in the ‘COMPONENT’ menu, then press the Enter but-
ton to shift to VGA output.
SCART connection setting
Connect the SCART output jack on the DVD Player to the Display
device’s SCART input jack with a SCART cable. Under this mode,
there is no need to do the setting in the setup menu.
NOTE: some player may do not have SCART&VGA connector.
Audio output connector
There are 2CH “L/R” analog audio output, 5.1CH output, optical
output, coaxial digital audio output for Audio connection use.