Elenberg DW-9001 - Инструкция (Страница 39)

39
PROBLEM POSSIBLE CAUSES WHAT TO DO
Dishwasher
doesn’t run
Fuse blown, or the circuit
breaker acted
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Power supply is not
turned on
Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Water pressure is low Check that the water supply is con-
nected properly and the water is
turned on.
Drain pump
doesn’t stop
Overflow The system is designed to detect an
overflow. When it does, it shuts off
the circulation pump and turns on the
drain pump.
Noise Some audible sounds are nor-
mal
Sound from soft food shredding ac-
tion and detergent cup opening.
Utensils are not secure in the
baskets or something small
has dropped into the basket
To ensure everything is secured in
the dishwasher
Motor hums Dishwasher has not been used regu-
larly. If you do not use it often, re-
member to set it to fill and pump out
every week, which will help keep the
seal moist.
Suds in the
tub
Improper detergent Use only the special dishwasher de-
tergent to avoid suds.
If this occurs, open the dishwasher
and let suds evaporate.
Add 1 gallon of cold water to the tub.
Close and latch the dishwasher, then
drain out the water by slowly turn-
ing the Dial until a drain period is
reached. Repeat if necessary.
Spilled rinse agent Always wipe up rinse agent spills im-
mediately.
Stained tub
interior
Detergent with colorant was
used
Make sure that the detergent is the
one without colorant.
Dishes are
not dried
Rinse agent dispenser is emp-
ty
Make sure that the rinse agent dis-
pense is filled.
BEFORE CALLING FOR SERVICE