Elenberg DW-9001 - Инструкция (Страница 28)

28
3. Place the end of the funnel (supplied) into the hole and introduce
about 2kg of salt. It is normal for a small amount of water to
come out of the salt container
4. Carefully screw the cap back on.
NOTE:
1. The salt container must be refilled when the salt warning light
comes on. Though the salt container is filled enough, the indica-
tor light may not black out before the salt fully dissolve.
2. If there are spills of the salt, a soak program could be run to wipe
them out.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount of
salt consumed based on the hardness of the water used.
This is intended to optimize and customize the level of salt con-
sumption so that the salt consumption could be set proceed as fol-
lows:
1. Unscrew the cap from the salt container.
2. There is a ring on the container with an ar-
row on it (see Figure to the side), if necessary,
rotate the ring in the anticlockwise direction
from the “-” Setting toward the “+” sign, based
on the hardness of the water being used. lt
is recommended that adjustments should be
made in accordance with the following schema:
WATER HARDNES
Selector
Position
Salt con-
sumption
(gram/
cycle)
Autonomy
(cycles /2
kgs)
Clarke
Degrees
°dH mmol/l
0-14 0-10 0-1.7 - 0 /
14-36 18-44 1.8-4.4 / 20 60
36-71 45-89 4.5-8.9 MED 40 40
71 89 8.9 + 60 25
Contact your local water board for information on the hardness of
your water supply.