Elenberg DW-9001 - Инструкция (Страница 30)

30
• To open the dispenser, turn the cap to the
“open” (left) arrow and lift it out.
• Pour the rinse aid into the dispenser, being
careful not to overfill.
• Replace the cap by inserting it aligned with
“open” arrow and turning it to the closed (right)
arrow.
The rinse aid is released during the final rinse to prevent water from
forming droplets on your dishes that can leave spots and streaks. It
also improves drying by allowing water to “sheet” off the dishes.
Your dishwashers are designed to use liquid rinse aids. The rinse
aid dispenser is located inside the door next to the detergent dis-
penser. To fill the dispenser, open the cap and pour the rinse aid
into the dispenser until the level indicator turns completely black.
The dispenser holds about 100 ml of liquid rinse aid.
Be careful not to overfill the dispenser, because this could cause
oversudsing. Wipe away any spills with a damp cloth.
Don’t forget to replace the cap before you close the dishwasher
door.
If you have soft water, you may not need rinse aid for it may cause
a white film to develop on your dishes.
Adjusting Rinse Aid Dispenser
A measured amount of rinse aid is released
during the final rinse. As with detergent, the
amount of rinse aid needed for your dishes
depends on the hardness of the water in your
area. Too much rinse aid can result in lather
of foaming and cause cloudiness or steaks on
your dishes. If the water in your area is very
soft, you may not need rinse aid. If you do you
can dilute the rinse aid with an equal amount of water.
The rinse aid dispenser has six settings. Always start with the dis-
penser set on” 1 “. If spots and poor drying are problems, increase
the amount of rinse aid dispensed by removing the dispenser lid
and rotating the dial to “2”. If the dishes still are not drying properly
or are spotted, adjust the dial to the next higher number until your
dishes are spot-free. We suggest you to set on “4”.
When to Refill the Rinse Aid Dispenser
If there is no rinse aid warning light in the control panel, you can
judge the amount of rinse aid by the following means. The black
RINSE AID DISPENSER