Beko CS 61110 - Инструкция (Страница 54)

Oven interior
Before switching on again ensure that all controls are in the
OFF position. Take out all trays and the grill out of the oven.
Clean out the interior with a piece of moist, soapy cloth.
Then, clean it once more with a wet piece of cloth and let
it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may be used
after carefully reading the warning that are written on the
labels.
Warning!
Never clean the inside of the oven and trays with hard brushes,
steel pads or knives.
Special cleaners that are commercially avaible may be used
after carefully reading the warning that are written on the
labels.
* Catalytic-enamel led models(if available); The
oven interior of this model is coated with catalytic enamel
since the catalytic enamel cleans itsellf, you do not have to
perform an e)ctra cleaning after the cooking operation.
if your oven obtains steei rack;
To clean the steel rack, unscrew
the 4 screws. After cleaning
operation, assemble the steel rack
to the oven body again.
Oven door
Wipe over the door outer panel with a cloth wrung out in hot soapy
water, then after wiping with a
doth wrung out in dear water. Do not use scouring pads or abrasive
powder which may scratch the surface. Take care during cleaning not to
damage or distort the door seal.
Replacing the oven lamp
(In models with lamp):
1. Unplug the power cable.
2. Then, remove theprotective glass cover
of the lamp inside your oven by turning it
counterclockwise
3. Then, remove the bulb by turning it
counterclockwise.
4. After installing the correct bulb obtained from an Authorized Service,
reinstall the protective glass of the lamp.
-
iW..
^ ar -
24