Panasonic NV-DA1ENA - Инструкция (Страница 14)

[ 1
^ ao 100%
J
POWER
[2^
80 100°-.
J
m m m m m
1 iiP_t^№7F ’ l§-t ’
±^± =
2 »a;iiiasa}SMsa±}ift •
(A) ■ '¥ ¡'’I-; h'~' ft
Bf ■ KiwiEiBaigs"
'S l|n. ) 'l'^.¡ij~' '■'
• -;ft ■ ■ '■ ;ft=^ ■ j ■ ■ -A-' 4 ^ r f ' - n
4 flc±ii^ili WffiS:^|Si ■ • K
* ® a j "
• |l '"-li V ---
ttM ■ •
6 si#mite)tA««s»«±M«afe)i ■ 3£isiT
ft» ■ SM*i%ie-aMSiiie °
. liA I 1 hH''^ '"J'”CT ' ®.'.;t til ilj ' & ' IR 4i r
• ■ ■. ■;:■■§’I "
• - ift^^fPOWCRiPtjil^iMSA^iOFFh
.A'ff-= ■ --ft:;. ^ 1—3 AfTif r ‘■'
■r 2 ■iRfiiftimSift/'V 3ovft^ ■
-: ■ -
ENGLISH
■ Supplying Power with the Battery
Before Lise, fully charge the Ballery.
1
Place the Battery on the AC Adaptor as
shown above and slide it horizontally until
it stops.
2 Connect the AC Mains Cable to an AC
mains socket.
®: Hong Kong Only
3 When all three Charge Lamps on the AC
Adaptor are lit, charging is finished.
•The Charge Lamps [50%], [80%] and [100%] flash
and then remain lit one after another.
•These lamps indicate the approximate charging
condition reached,
4 Remove the Battery by sliding it in the
opposite direction of Step 1 above.
•Also disconnect the AC Mains Cable.
5 Slide the Finder backward to its fully
extended position and then tilt it upward.
6
Insert the Battery into the Battery Holder
on the Movie Camera and slide it
downward until it locks with a click.
Removing the Battery from the Movie Camera
While pressing the [BATTERY EJECT] Button, slide the
Battery upward to remove it.
• Be careful not to drop the Battery by accident.
• Before removing the Battery, set the [POWER] Switch
to [OFF].
Charging Two Batteries
If you attach two Batteries to the AC Adaptor, they will be
charged one after the other.
To charge, follow Steps 1-3 above.
• Charging starts from Battery 1, At this time, the Charge
Lamps for Battery 2 show the remaining charge in the
Battery
2.
(If the remaining charge is less than 50%, no
Charge Lamp is lit.)
18-