Panasonic ES-LV95 - Инструкция (Страница 18)

18
English
 ►Whenthewaterdoesnotdrainfromthecleaning
tray
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the shaver.
Push the beard trimmings down through the
drain with a toothpick etc.
Troubleshooting
 ►Self-cleaningrecharger
Problem Action
The blade has not been
thoroughly washed.
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to remove
beard trimmings. (See page 16.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function. (See page 14.)
After cleaning, oil‑like droplets
may remain on the outside of the
foil frame. This is the lubricating
component of the cleaning liquid
and does not indicate a problem.
You may wipe it off with a soft
cloth.
The STATUS lamp glows. See page 21.
Problem Action
The mode does not start.
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the recharger
is plugged in to a household
outlet. (See page 10.)
Confirm that the shaver is
properly attached to the self‑
cleaning recharger.
(See page 10.)
The Clean or Dry operation may
not function under extreme low
temperatures (approx. 0 °C or
lower).
Check if the STATUS lamp glows.
(See page 21.)
Cleaning liquid has
accumulated in the
cleaning tray.
Remove any waste, etc. that has
accumulated in the drain at the
bottom of the cleaning tray.
(See this page.)
If you use the self‑cleaning
recharger when the shaver is wet
or when soap or shaving gel is on
the shaver, cleaning liquid may
accumulate in the cleaning tray.
The cleaning liquid unit
cannot be removed.
Place the self‑cleaning recharger
on a hard, flat surface.
When the self‑cleaning recharger
is lifted, or on the soft surface
such as carpets, the lock release
lever will not fit in the recharger
properly. In that case, the cleaning
liquid unit cannot be removed.