Charge – Инструкция по эксплуатации Panasonic ES-LV95
Страница 10
10
English
Usingthelockring
Use the lock ring to lock or unlock the power switch.
Rotate the lock ring until it clicks.
Rotatethelockringto“ ”tounlockthepower
switch:
Used when shaving, washing the shaver, lubricating
the shaver.
Rotatethelockringto“ ”tolockthepower
switch:
Used when carrying the shaver.
Charge
Chargingusingtheself-cleaningrecharger
Thoroughly wipe off any drops of water on or around the self‑
cleaning recharger so that it is dry before charging the shaver.
1
1
Inserttheappliancepluginto
theself-cleaningrecharger.
2
2
Removetheprotectivecap
andthenattachtheshaver.
• Turn the shaver off before attaching.
• Wipe off any water droplets on the
main body rear terminals.
1
2
3
• Check that the outer foil is not deformed or damaged when
you are attaching the shaver.
3
3
Plugintheadaptorintoahouseholdoutlet.
• The “Charge” mode starts when attaching the shaver.
• Check that the charge status lamp ( ) glows.
• Charging is completed after approx. 1 hour.
The charging time may decrease depending on the
charging capacity.
While charging
After charging is completed
The charge status lamp ( )
glows.
The number of the battery
capacity lamp will increase as
charging progresses.
The battery capacity lamp and
the charge status lamp will
light up and then turn off after
5 seconds.
Abnormal charging
The charge status lamp ( ) will blink twice every second.
• After charging is completed, turning the power switch ON with
the shaver plugged in will cause the battery capacity lamp and
the charge status lamp to light up and then turn off after 5
seconds.
This shows that the shaver is fully charged.
• Recommended ambient temperature for charging is 10 – 35 °C.
It may take longer to charge or the battery may fail to charge
properly in extremely high or low temperatures.
Charge the shaver within the recommended ambient temperature
range.
• When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp ( )
may not glow. It will eventually glow if kept connected.