Panasonic ES-LV95 - Инструкция (Страница 14)

14
English
4 4
Pourtapwaterand
detergentintothe
cleaningliquidunit.
• Do not let the water rise
above the maximum water
line. This may cause the
cleaning liquid to spill.
2 1
5 5
Attachthecleaningliquidunit.
• Immediately wipe up any cleaning liquid
that has been spilt.
Be careful not to drop cleaning liquid
onto leather products or wooden floors
as it may cause discoloration.
6 6
Pressthetopoftheself-
cleaningrechargerdownand
securelyattachuntilitclicks.
 ►Notes
• The water and detergent will mix after cleaning begins, making
cleaning liquid.
• When the cleaning liquid level has dropped, the LOW lamp will
glow to indicate the cleaning liquid should be replaced.
• After the LOW lamp glows, you can clean the shaver with the
self‑cleaning recharger for approximately 7 days.
• Replace the cleaning liquid when the STATUS lamp glows.
• When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on beard
thickness and the ambient temperature.)
• Use the detergent within approximately 6 months after opening
the package. When 6 months have passed, discard the cleaning
liquid, and then pour new water and detergent into the cleaning
liquid unit.
• Replace the water and detergent at the same time.
Otherwise the cleaning function may deteriorate.
• Only use self‑cleaning recharger detergent for Panasonic shavers.
 ►Cleaningtheshaver
Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
1 1
Inserttheapplianceplug
intotheself-cleaning
recharger.
2 2
Removetheprotectivecap
andthenattachtheshaver.
3 3
Plugintheadaptorintoa
householdoutlet.
1
2
3
• Turn the shaver off before attaching.
• Wipe off any water droplets on the main body rear terminals.
• Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
4 4
PresstheSELECTbuttontoselectthemode.
• The “Charge” mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode changes
from “Clean/Dry/Charge” “Dry/Charge” “Charge”.
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this case,
perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as the
cleaning liquid may spill causing a malfunction.