English, Use of the kebbe attachment, Use of the sausage attachment – Инструкция по эксплуатации Binatone MGR-3002
Страница 7: Use of the circuit breaker
7
7. After use switch the appliance off and unplug it from the wall
outlet.
Note:
The grinder will mince up to 1.5 kg of meat per minute.
If the operation slows down or the motor stops, it means that
probably some pieces of meat are stuck in the grinder.
Immediately switch the appliance off. Wait till the
appliance stops fully. Press briefly reversal button (3).
This will facilitate movement of meat in the opposite
direction. Release the button (3) and switch the grinder
on again. If the meat is still stuck in the grinder, switch
it off and unplug it from the wall outlet. Disassemble
and wash the appliance according to instructions.
If the appliance mince the meat badly, check if the cutter (9)
is installed correctly or the feeding container nut (11) is
fully twisted.
Use of The Kebbe Attachment
Insert the screw
1.
(8) into the feeding container (5).
Put the two-element Kebbe attachment
2.
(14) onto the end of the screw
(8). Make sure the projections on the feeding container (5) match
the slots on the attachment. Tighten feeding container nut (11).
Fasten the assembled feeding container
3.
(5) onto the housing (1).
Place the tray
4.
(6) on top of the funnel of the feeding container
(5). The appliance is then ready for operating. A Kebbe recipe is
provided in the “Useful tips”.
Use of The Sausage Attachment
Insert the screw
1.
(8) into the feeding container (5).
Put the cross-shaped cutter
2.
(9) on the end of the screw (8) so that
the rounded tip of the cutter (9) is facing the screw (8). Make sure
the cross-shaped cutter (9) is properly fixed.
Place the selected perforated disc
3.
(10) on top of the cutter (9) so that
the projection on the feeding container (5) fit the slot in the disk.
Place the sausage attachment
4.
(12) onto the end of the screw (8).
Make sure the projections on the feeding container (5) match the
slots on the attachment. Tighten the feeding container nut (11).
Fasten the assembled feeding container
5.
(5) onto the housing (1).
Attach the tray (6).
Place the sausage casing on the end of sausage attachment
6.
(12)
for filling.
Put the sausage mixture into the feed tray
7.
(6). Switch on the
appliance. Direct the sausage mixture with the pusher (7). Sausage
casings will be filled automatically.
Use of The Circuit Breaker
This appliance is equipped with a circuit breaker. This system will
automatically cut off the power supply to the appliance in case of
overloading.
ENGLISH