Инструкция по эксплуатации Beko CG 61110 G
Страница 39
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Ov«n inferior
Before
switching
on ogoin ensure
that ail controls
are in the OFF position. Take out all frays and
the grill out of the oven. Clean out the interior
with a piece of moist, soapy cloth. Then, clean
it once more with a wet piece of cloth and let
it to dry.
Do not use dry powder agents for
cleaning.
Special cleaners that are commercially available
may be used after carefully reading the warning
that are written on the labels.
Warning!
Never clean the inside of the oven and trays
with hard
brusijes, sfee/
pads or knives.
Special
cleaners
that
are
commercially
avaible
may be used after carefully reading the warning
that are written on the labels.
in'
Catalyfic-enameiled models 0 available);
The
oven interior of this model is
coatee/
with
catalytic enamel since the catalytic enamel
cleans itsellf, you do not have to perform an
extra cleaning after the cooking operation.
If your oven obtains steel
rack;
To clean the steel
rack, unscrew the 4 screws.
After cleaning operation,
assemble the steel rack to
the oven body again.
Confrei panel
Wipe over the control panel with a damp
clofhand polish with a dry cloth. Do not use
oven cleaners or aerosols, scouring pads or
abrasive powder for cleaning the plastic knobs
as damage will occur. Do not attempt to
remove any of the control knobs from the
panel as this may cause damage and is a
safely hazard.
Oven door
Wipe over
f/ie
door outer panel with a cloth
wrung out in hot soapy water, then after
wiping with a cloth wrung out in clear water.
Do not use
scouring
pads or abrasive powder
which may scratch the
surface.
Take care
during cleaning not to damage or distort the
door seal.
Replacing file even lamp!
I. Unplug the power cable.
2t Then, remove fheprotective glass cover of the lamp inside
your oven by turning it
counterc/oc/cwise.
3.
Then, remove the bulb by turning it counterclockwise.
4.
After installing the correct bulb obtained from an
Auf/iorizec/
Service, reinstall the protective glass of the lamp.
15