Beko CG 61110 G - Инструкция (Страница 31)

Operating the hot pintes
HatpiafB coniroi posifion
Corresponding Cooking Voiocs
I 2 \ 3 4 5 1 6
Application Worming Simmering Cooking-Fiying-Boiting
A rapid heaUng hotplate i$ denoted by a red spot in
the centre of the hotplate:
flofplafe operating knobs
The knobs for the hob can be rotated in either direction
to provide fully variable heat control. When any one
of the hotplates is on, tile red Indltater light
on the sontrol panel will be on.
In order to switch the hotplate OFF turn the corresponding
knob to ffie 0 ( z e r o ) position. Knobs of the hotplates
can be turned both clockwise and counter-clockwise
directions.
Cheek that all the coolrer eentrels have
been switehed off €ifler use.
Adjust the hotplates to mid position (3j and leave on
for opprox/mafe// 8 minutes in order to burn off the
protective coating on the hotplates. Do not place any
pans or other cooking utensil on the hotplates during
this process. Fumes will be emitted during the above
operation but this is quite normal.
Good Quality Pans
«•“ Uie only good quality pans having a stable bottom as sfiov/n below. This
results in the maximum use of energy.
w Use pans for the correct diameter
only. If the pan is too small energy is
wasted.
** Do not place pans with wet bases
or pan lids particulary wet lids on the
hotplates damage could occur and
safety problem will be experienced.
Right Pan
fCarracf MixȒ
Wrong Pan
fli»a MnaffJ
Hotplate diameter
(mm)
0 160 mm
Suggested diameter
of the pan (mm)
180-200
** Drying
the
hotplates
(max 5 min)
When cool;
iw Clean off solid hotplates v/if/i a damp cloth and a little domestic cleaning
cream. After cleaning, dry solid hotplates by switching on for a short time.
Apply a thin coat of cooking oil from to time.
When wiping the hotplates with a damp cloth follow the circular grooved
pattern on the hotplate.