Part 6: maintenante and tieaning, Turn off the mains switch before cleaning, Vitreous enamel hob surround – Инструкция по эксплуатации Beko CG 61110 G
Страница 38
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
P a r t 6 :
Maintenante and tieaning
Turn off the mains switch
before cleaning
Before switching on again ensure that
all controls are in the OFF position.
Make sure that the oven, grill before
you start cleaning.
Your
product is
monu/bcfurec/ in
a
manner that it should not overflow the
oily food juices under the
counfer.
The
pan supports can easily be removed
and the top burner plate con be cleaned
with soapy water, and
rinsed
with a dry
cloth.
w
Wash and rinse the gas burner caps
and the pan supports with soapy water.
Never wash
the
gas burner caps
and the pan supports in the
dishwasher.
For the dirts and stains
on the burner heads that can not be
cleaned, use the metal surface cleaners
you con obtain from the
moritef
according to their
insfruciions.
w
It is recommended that the acidic
matters such as oil, lemon etc. should
be cleaned immediately.
Use a damp cloth to clean the interior
and exterior. Never use any sharp
instruments, abrasive household cleaner,
or detergents for cleaning. For hard
stains use suitable washing liquid.
Vitreous enamel hob surround
Clean with a cloth wrung out in soapy
water. Stubborn stains can be removed
with a cream, paste or liquid cleaner.
Check that the cleaning agent used is
approved by the Vitreous Enamel
Development
Council.
cap
head
Control panel
Wipe over the control panel with a damp
cloth and polish with a dry cloth. Do not
use oven cleaners or aerosols, scouring
pads or abrasive powder for cleaning
the plastic knobs as damage will occur.
Do not attempt to remove any of the
control knobs from the panel as this may
cause damage and is a safety hazard.
Oven doer
Wipe over the door outer panel with a
cloth
wrung oui in
hot soapy water, then
after wiping with a cloth wrung out in
clear water, dry with a soft clean cloth.
Do not
use
scouring pads or abrasive
powder which may scratch the surface.
Take care
during
cleaning not to
damage
or
distort the door seal.Ensure that the
door seal is dry after
cleaning.
M