Beko CG 61110 G - Инструкция (Страница 32)

P a r t S :
Operating the oven anti grill
Operating the oven
In modds with thermostat; Gas flow rate can be adjusted
by the 8 different knob positions for cooking desired.
In models without thermostat; Gas flow rate can be
adjusted by the 3 different knob positions for cooking
desired.
The oven and/or the grill is controlled by the same knob.
When you turn the knob in the counter-ciockwise direction
it indicates the oven position and gas is supplied to the
oven burner.
Bring the oven control knob to the oven position by
pressing and rotating in the counter-clockwise direction,
for the models vdHiout ignition;
While the knob is in pressed position , ignite from the
ignition control hole on the boftom surface by a lighter
or a match and waif to ignite,
for tite models with electrical ignition;
While the knob is in pressed position, press the ignition
button.
You can check the starting and continuation of the
ignition from the control hole.
•^After the gas in the oven burner is ignited, keep the
knob in the pressée/ position for 5-10 seconds. After
you release the knob, if the ignition does not continue
repeat the same process by keeping the knob pressed
for 15 seconds. If still no ¡gniton occurs, wait for
1
minute and repeat again.
Warning : Do not keep Hie knob in pressed position
more than 15 seconds.
Flame Failure Device :
There is a fíame failure "safety
device" in the oven. If the flame
exflnguis/ies for any reason in
the grill or oven burners, the
safety device immediately cuts
off the gas flow and prevents
unbumed gas collection inside
the oven.
Warning:
When using the oven for the first
time let the burner operate for
20 minutes at position 6 (In
models with tap, position 2}
with empty oven, so that possible
grease residuals and bad smells
due to insulating material can
be eliminated.
For a rational
use of the oven
and to obtain its best
performances refer to the
cooking table.