Инструкция по эксплуатации Beko CG 61110 G
Страница 27
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Part Important Installation and preparation of your oven
w Before your
appliance is
connecfeJ
to the gas supply,
check the ensure that the gas
category and pressure
specifications shown in the data
plate corresponds with your gas
supply. If necessary call
authorized service
for
adjusting to gas category.
<^This
appliance
shall
be
installed in accordance with the
regulations in force and only
used in a well ventilated space.
Read
the
instructions
before
installing or using this appliances.
In the interest of safety this
appliances
must
be
installed
and/or serviced by a competent
person as
stated in the gas safety
regulations current editions,
»•
Please refer to the data plate
for details about gas supply and
pressures.
The
opp//ance
must not be
installed in a room without a
window
or
other
controllable
opening. If is installed in a room
without
a
door
which
opens
directly
to
tohe
outside,
a
permanent opening is required.
The air circulation should be 2
m3/h per kW of burners.
Connection of the gas hoso
to the even
Convenient position is selected by
interchanging the hose nozzle and
plug according to the location of the
main gas inlet valve. If you make a
connection with a flexible metal hose
, locate a seal between the main gas
pipe. The inner diameter of the flexible
hose, which the butane hose nozzle is
connected, should be 6mm for the
house-type gas tubes.
The inner diameter of the flexible hose,
which
the
natural
hose
nozzle
is
connected, should be 15mm. The hose
should tightly be fitted to the hose
nozzle by
sqLfeezing
with a clamp. The
plastic hose end is soaked in hot water
for one minute to soften and inserted
fully into the hose nozzle. The clamp
is fastened securely by a screw driver.
The other end of the hose is
connecter/
fo
the
gas
valve
with
the
same
operation.
The hose should be replaced
before
its last expiry date.
Caution!
Make the oven connection to the
gas inlet valve, the hose length
must be short and be sure that
there is no leakage. The hose
used should not be longer than
125 cm for safety.
Connectíon of Hie gas hose
to Hie
even
Convenient position is selected by
/nterc/iong/ng
the hose nozzle and
plug according to the location of
the main gas inlet valve. The plastic
hose end is soaked in hot wafer
for one minute to
soften ond
inserted fully into the hose nozzle.
The clamp is
fastened
securely by
a screw
dnVer.
The other end of
the hose is connected to the gas
valve with the same operation.
Oas leakage
eenfrel
During
control, be sure that the
control knobs are closed and the
gas inlet valve is open. Apply soap
bubbles to the connections for
leakage control. In case leakage
exists, buble will
oppear.
In such
case, check the gas connection
immediately. Do not control gas
leaks by using fire.
Cnvfienf
Never
use lighter or
match flame, for
con№o//irtg ffie
gas
lackage.
Hose nozzle and
elbow types for
Natural gas and
Butane/propane