Troubleshooting – Инструкция по эксплуатации Panasonic CS-W9

Страница 10

Advertising
background image

10

TROUBLESHOOTING

The following symptoms do not indicate malfunction.

The following symptoms do not indicate malfunction.

SYMPTOM

SYMPTOM

CAUSE

CAUSE

Mist emerges from indoor unit.

► • Condensation effect due to cooling process.

Water fl owing sound during operation.

► • Refrigerant fl ow inside the unit.

The room has a peculiar odor.

► • This may be due to damp smell emitted by the wall,

carpet, furniture or clothing.

Indoor fan stops occasionally during automatic fan speed

setting.

► • This helps to remove the surrounding odours.

Operation is delayed a few minutes after restarting.

► • The delay is a protection to the unit’s compressor.

Outdoor unit emits water/steam.

► • Condensation or evaporation occurs on pipes.

TIMER indicator is always on.

► • The timer setting repeats daily once set.

POWER indicator blinks during operation and the indoor

fan is stopped.

► • The unit is in defrost mode, and the melted frost is

drained from the outdoor unit.

Indoor fan stops occasionally during heating operation.

► • To avoid unintended cooling effect.

Cracking sound during operation.

► • Changes of temperature caused the expansion/

contraction of the unit.

Check the following before calling for servicing.

Check the following before calling for servicing.

SYMPTOM

SYMPTOM

CHECK

CHECK

Heating/Cooling operation is not working effi ciently.

► • Set the temperature correctly.

• Close all doors and windows.

• Clean or replace the fi lters.

• Clear any obstruction at the air inlet and air outlet vents.

Noisy during operation.

► • Check if the unit has been installed at an incline.

• Close the front panel properly.

Remote control does not work.

(Display is dim or transmission signal is weak.)

► • Insert the batteries correctly.

• Replace weak batteries.

The unit does not work.

► • Check if the circuit breaker is tripped.

• Check if timers have been set.

The unit does not receive the signal from the remote

control.

► • Make sure the receiver is not obstructed.

• Certain fl uorescent lights may interfere with signal

transmitter. Please consult authorized dealer.

Advertising
Эта инструкция подходит к следующим моделям: