Changing the harness position, Выбор положения плечевых ремней – Инструкция по эксплуатации Evenflo Discovery Madeline
Страница 8
7
10
11
Push the harness anchor
A
located on the back of the
child restraint through the slot to the front of the seat
shell. Repeat this procedure on both sides.
As your child grows, you will need to change the harness
strap position so that the harness straps are routed through
the slots closest to the child’s shoulders.The shoulder harness
straps should
ALWAYS
be as close as possible to, but
NEVER
above, the child’s shoulders.
Pull the harness
strap and anchor
A
to the front of the
seat shell. Repeat
this procedure on
the opposite side.
Pull the harness strap from the back of the carrier while
pushing the chest clip
B
, buckle tongue, harness
anchor and harness strap through to the back.
�
Choose the appropriate slots for the new harness
position. Push the harness anchor
A
, buckle tongue,
and harness strap and chest clip through to the front of
the child restraint. Repeat for the other harness strap.
NOTE: Harness strap should start at or below the child’s
shoulders.
Changing the Harness Position
6
1
2
4
5
A
3
Pull the harness
anchor
A
, harness
strap, buckle
tongue, and chest
clip to the front of
the child restraint.
Push the harness
anchor
A
through
the pad to the
bottom of the child
restraint.
Pull the harness anchor
A
through the bottom of the
child restraint, and clip into place. Repeat on the
opposite side.
7
A
B
A
A
A
A
Выбор положения плечевых ремней
По мере роста ребенка вам потребуется изменить
положение плечевых ремней таким образом, чтобы они
проходили через наиболее близкие его плечам прорези.
Прорези для плечевых ремней должны быть как можно бли-
же к плечам ребенка, но ни в коем случае
НЕ ВЫШЕ плеч.
Протолкните крепление
А ремня из нижней части люльки
наружу через прорезь в передней части. Повторите опера-
цию для обеих сторон.
Вытяните ремень и
крепление вперед.
Повторите операцию
для второй стороны.
Протолкните крепление, ремень, грудной зажим
В и пряжку
ремня назад, одновременно вытягивая ремень со стороны
спинки.
Протолкните через выбранную прорезь наружу крепление
А, пряжку, грудной зажим и ремень. Повторите для второй
стороны. Внимание: Ремень должен находиться на уровне
плеч ребенка или ниже их
Вытяните крепле-
ние, ремень, пряжку
и грудной зажим
наружу.
Проденьте крепление
А через отверстие в
чехле чехол и нижнюю
часть кресла.
Вытяните крепление
А через нижнюю часть кресла и за-
крепите на месте. Повторите для второй стороны.