Olympus DS-10 - Инструкция (Страница 8)

8
Notes
• Be sure to stop the recorder before replacing the
batteries. Unloading the batteries while the recorder is
recording, erasing or otherwise accessing an audio file
may corrupt the file. If you are recording into a file and
the batteries run out, you will lose your currently recorded
file because the file header will not be able to close. So,
it is crucial to change the batteries once you see only one
mark in the battery icon.
• Be sure to replace both batteries at the same time.
• Never mix old and new batteries, or batteries of
different types and/or brands.
• If it takes longer than 1 minute to replace dead batteries,
you may have to reset the time when you load fresh
batteries (
☞ P.9).
• Remove the batteries if you are not going to use the
recorder for an extended period of time.
1 Lightly press down
on the arrow and
slide the
battery cover
open.
2 Insert two AAA
alkaline batteries,
observing the
correct
polarity.
3 Close the battery cover
completely.
Inserting Batteries
• Always stop recording before connection
or disconnection.
• When the AC adapter is not in use,
disconnect the power supply plug from
the power outlet.
• Use only the correct power supply
voltage as indicated on the adapter.
• Do not use the AC adapter when
connecting the recorder to the USB port.
Replacing batteries
The battery indicator on the display changes
as the batteries lose power.
→ → →
When appears on the display, replace
the batteries as soon as possible.
When the batteries are too weak, the recorder
shuts down and “BATTERY LOW” appears
on the display. AAA alkaline batteries are
recommended.
“BATTERY
LOW”
Plug the optional AC adapter (Olympus Model
A321 or A322) into household power outlet
and connect the power plug to the recorder’s
power connector (DC 3 V) as shown in the
illustration. Always stop recording before
connection. Otherwise it may not be possible
to play back the voice data being recorded.
Using the AC Adapter
Inserting Batteries / Using the
AC Adapter