Troubleshooting – Инструкция по эксплуатации Sony CD Walkman D-NE509

Страница 27

Advertising
background image

27

-GB

Troubleshooting

Should any problem persist after you have checked these symptoms, consult your nearest Sony
dealer.

Symptom

The volume does not
increase even if you press
the VOL + button repeatedly.

No sound, or noise is heard.

Certain files cannot be
played.

The playing time is too short
when powered with the dry
batteries.

“Lo batt” appears on the
display. The CD does not
play.

“HI dc In” appears on the
display.

The CD does not play or
“No disc” appears on the
display when a CD is placed
in the CD player.

“HOLD” flashes in the
display when you press a
button, and the CD does not
play.

Cause and/or corrective actions

c If “AVLS” flashes in the display, press and hold SOUND/AVLS

until “AVLS OFF” appears on the display. (page 22)

c Connect the plugs firmly. (page 11)

c Plugs are dirty. Clean the plugs with a dry soft cloth periodically.
c You tried to play files saved in a format that is not compatible with

this CD player. (page 6)

c Check that you are using alkaline batteries and not manganese

batteries. (page 24)

c Replace the batteries with new LR6 (size AA) alkaline batteries.

(page 24)

c Replace the batteries with new LR6 (size AA) alkaline batteries.

(page 24)

c An AC power adaptor which is rated highter than the one supplied

or recommended is being used. Use only the AC power adaptor
supplied or recommended, or the car battery cord supplied or
recommended. (page 30)

c The buttons are locked. Slide the HOLD switch back. (page 22)

c The CD is dirty or defective.

c Check that the CD is inserted with the label side up. (page 11)

c Moisture condensation has occurred.

Leave the CD player aside for several hours until the moisture
evaporates.

c Close the lid of the battery compartment firmly. (page 24)

c Make sure the batteries are inserted correctly. (page 24)

c Connect the AC power adaptor to an AC outlet securely. (page 11)

c Press u after one second or more has passed since the AC power

adaptor was connected.

c The CD-R/RW is blank.

c There is a problem with the quality of the CD-R/RW, recording

device, or application software.

c Files in two or more formats have been recorded on the same

CD-R/RW. (pages 6, 7)

c The buttons are locked. Slide the HOLD switch back. (page 22)

Additional information

(Continued)

Advertising