Problem, Causes what to do – Инструкция по эксплуатации Sharp SJ-GF60AT
Страница 51
51
If you think cooling or ice making performance does not
work well, unplug it once and then plug it again in 5 minutes,
and then wait and see how it works.
Wait and see for half a day after operating “Ice tray cleaning ”
if ice cubes are not made even after the confirmation on the above.
Problem
Page
43
Just after refrigerator installation, it takes long time for ice making
because it takes long time before refrigerator compartments get cool.
43
42
44
42
42
48
Causes
What to do
The replacement period of water purification
filter is 3 to 4 years as a rough estimate.
Is it time for replacement of water
purification filter?
42
43
47
Ice cubes
are not
made
The amount
of ice is less
Ice cubes
smell
Is it set to the Energy saving?
Wait and see after canceling.
It takes time for ice cube making
if mode is set to Energy saving.
42
Ice cubes are
made slow
Ice cubes are small,
rounded or
connected.
There is protrusion
or holes in
ice cubes.
44
39
48
page
Is there water in the water tank?
Is the water tank securely set?
Are you leaving the shovel or other
food products in the ice case?
Is the “Stop” lighting?
Pour the water.
Make sure to insert it all the way in until you hear a click.
Switch the ice making mode you want.
Store the shovel and other food
products in their specified positions.
Deteciton lever
Determines
that full ice
Do ice cubes pile up in the
back of the ice case?
Spread out
the ice
cubes evenly.
Has automatic ice maker just been
restarted?
Has water just been refilled in
the water tank?
Refer to
“Refrigerator
does not
cool well
”
at first.
It takes more time to make large
ice cubes than normal size.
Have you chosen “Large”?
Ice cubes may become small or connected to each
other, especially just before or after water supply.
If you store ice cubes for a long time, they may become
smaller, rounded, or attached to each other.
The protrusion you may see comes from the slit in the ice tray.
The hole comes from air bubbles in ice cubes which may gather together and form a bigger hole.
You can separate the
ice cubes connected
to each other using a
shovel or something.
These are the chips from the protrusion or the corner of ice cubes.
You can remove them with a shovel if that bothers you.
Ice chips are
piling up.
For hygienic reasons, replace the water
in the water tank once a week.
Is there remaining detergent or bleach
used during cleaning in the water tank?
Rinse off any detergent thoroughly.
Is the water in the water tank old or
with odor?
If ice cubes has been left unused for a long time, odors of food may transfer on to the ice cubes.
This is the minerals contained in water. They get solidified as the water freezes.
There is something white
in ice cubes. When the
ice melts, floating
substances remain.
Is the ice case full with ice cubes?
Are you leaving the shovel or other food products?
Is there water in the water tank?
Empty the ice case and put water
in the water tank to clean it.
No water or ice cubes
drop even when
performing
"Ice tray cleaning"
Opening or closing the door of the ice compartment in a rough way may send
some of the ice cubes into the freezer compartment (lower).
There are some ice cubes
dropped in the freezer
compartment (lower)
<Ice making>
It takes time to start ice making
because water supply does not work
soon after setting the water tank.