Sharp SJ-GF60AT - Инструкция (Страница 46)

46
Care of parts in the refrigerator
Remove and wash
(The detergent which can be used )
Push the front
sectioninto the
back section.
Put in the right and
left tabs as shown.
Remove two shelves.
Press in the front
section and push in.
Pull up to remove.
Pull it fully.
Remove in the direction
of the arrow.
A
Shelf
Lift up the front side, and
pull it halfway.
If you hit a hook to the
tabs, pull it and lift more.
Recline shelf downwards,
and remove.
Shelf is attached to by two type of height.
Install here
certainly
• The whole of freezer case (small)
and small case of the vegetable
compartment should face the front
with “FRONT” mark.
• Insert the moisture seal box in
the vegetable compartment after
pressing the small case to be in.
Pull out the door.
Remove the case.
Vegetable
compartment
Freezer
compartment
Ice making
compartment
With the door by lifting it up slightly, pull it out further.
Pulling too much, the door comes off.
Release the lock for small case and take it out.
Remove the lower case.
Take out the stainless plate from the back side of case.
"FRONT"
Free set shelf
Insert in the two
tabs.
Lift up and remove the pocket while
tapping the bottom surface on the
left and right alternatively.
(The pocket is fixed
a little tightly in order
not to be dropped.)
tapping
tapping
Cases Pockets
45
page page
Side
view
Tab of the wall
Shelf
Hook
Tab of the wall
Hook
Front
side
Place by inserting the
shelf on the rails. Insert by fitting the
back tabs.
Shelf
Tab
Upper rail
Hook of lower part
Low
High
Back tab
Hook
Unable to
insert inside and
hit the front tab.
How to remove
How to install
How to remove
How to install
Back section
Front section
Tab
How to fit A part
Front
section
Back section
Front side
Door
Pocket
Tab
View from
above
Pay attention
to your feet.
The figure shows
the freezer
compartment
(lower).
How to remove How to remove
How to install
How to install