Connection of speaker systems, Connection of ac power cable – Инструкция по эксплуатации Marantz PM6003

Страница 13

Advertising
background image

8

NAMES AND

FUNCTIONS

BASIC

CONNECTIONS

BASIC

OPERA

TION

ADV

ANCED

CONNECTION

REMOTE CONTROLLER

OPERA

TION

TROUBLESHOOTING

OTHERS

BASIC

CONNECTIONS

ENGLISH

BASIC CONNECTIONS

CONNECTION OF SPEAKER SYSTEMS

This unit is equipped with two sets of SPEAKER SYSTEM terminals––SYSTEM A terminals and SYSTEM B
terminals. Usually connect your speaker system to the SYSTEM A terminals.

• The speakers in the speaker system should have an impedance between 8 and 16 ohms. If speakers with

an impedance of less than 8 ohms are connected, the protection circuitry may be activated during play.

• Connect the Right channel speaker to the R terminals, and the Left channel speaker to the L terminals.

• The output terminals have positive (+: Red) and negative
(–: Black) polarity, and each speaker also has the same polarity (+ and –). When connecting the speaker,

be sure to connect the terminals with the same polarity (+ with +, – with –).

• When connecting just one speaker set, you can obtain better sounds quality by connecting to SYSTEM

A.

WIRING SPEAKER CABLE

• Be careful not to short circuit in wiring speaker

cables.

• Peel off the corting of speaker cable as shown

below.

Approx. 1 cm

Cut the
corting of
cable.

Peel off the
edge of cable.

Twist
conductors.

• Wiring with speaker cable.

Turn counter-
clockwise to
loosen.

Insert
conductor of
cable.

Turn
clockwise to
tighten.

Your speaker system must satisfy the below
conditions. If it does not, the PM6003’s protective
circuit will active, whereby preventing proper
playback. In some cases, the amplifi er and speakers
may be damaged.

• If using 1 set of speakers, total speaker impedance

must be 4 ohms or more.

• If using 2 sets of speakers, total speaker

impedance must be 8 ohms or more.

CONNECTION OF AC
POWER CABLE

1.

Plug the power cable into AC IN jack on the

back panel.

2.

Turn on the power switch of the audio unit

(amplifi er, etc.) that is connected with this
unit. Set the selector on the connected unit
to this unit.

3.

Plug the power cable into an AC outlet.

PM6003_N_01_Eng_New.indd 8

PM6003_N_01_Eng_New.indd 8

09.4.20 3:57:54 PM

09.4.20 3:57:54 PM

Advertising