Alinco DR-135 FX/E/T - Инструкция (Страница 44)

12. Приложение
Список команд TNC
Все команды поддерживаются встроенным TNC. Вы должны ввести про-
бел между названием команды и параметром или между двумя парамет-
рами.
Команд а Короткая
форма
По
умолчанию
Параметры Описание
AUTOLF AU ON ON/OFF When ON, sends a line feed (LF) to the PC
after each carri age return (CR).
BEACON B EVERY 0 EVERY/
AFTER n
( n=0 – 2 50 )
If set to EVERY, sends a beacon packet at
intervals o f the specified period (n). If set to
AFTER, sends a beaco n packet only o nce
after the sp ecified period (n). The unit of n is
10 seconds.
BTEXT BT - 0 –159 charac-
ters
Specifies the content of the data portion of a
beaco n packet.
CALIBRAT CAL - - Se nds a space/mark square wave (50/50 ra-
tio). Enter Q to exit Calibrate mode and restore
the Command mode.
CHCAK CH 30 0 – 250 Specifies the interval fro m signal d rop-out until
execution of disco nnectio n. The unit of the
parameter is 10 seco nds.
CONNECT C - Call1 (VIA
call1, ca ll3,
....call9)
Sends a co nnect request. Call 1 is the call sig n
of the sta tion to be connected to. Ca lls 2 to call
9 are call signs of stations to be digipeated
through.
CONVERSE CONV or - - Causes the TNC to enter Converse mode.
Press [Ctrl]+[C] to restore the Command
mode.
CPACTIME CP OFF ON/OFF When ON a nd in Converse mode, sends a
packet at intervals of the p erio d determine by
PA CTIME
CR CR ON ON/OFF When ON, appends a carriage return (CR) to
all packets to b e sent.
DISCONNE D - - Se nds a disconnect request.
DISPLAY DISP - - Causes the TNC to display the current status
of all the commands. Yo u can also sp ecify a
class identifier A, C, H, I, L, M, or T to disp lay
the status of only the desired command class.
Enter a sp ace between the command name
and a class ide ntifier; ex. DISPLA Y H.
A (ASYNC): RS-232C port parameters.
C (CHAR) : Special TNC characters
H (HEALTH): Counter parameters.
I (ID): ID parameters.
L (LINK): TNC-to -TNC link status.
M (MONITOR): Monitor p ara meters.
T (TIMING): Timing parameters.
DWAIT DW 30 30 Specifies the interval from no carrier detection
until e xecution o f transmission. The unit of the
parameter is 10 milliseco nds.
ECHO E ON ON/OFF When ON, causes the TNC to echo received
characters to the computer.
42