Beko CG 61110 G - Инструкция (Страница 40)

Porf Oms converflon
Your cooker can operate both
Natural Gas and LPG. You can
convert by changing the gas
source and the top burner, oven
and grill i n j e c t o r s . T h e
replacement procedure of the
injectors are explained below.
Call authorized Service for gas
convertion.
Replacement of the top
burner injector
Take off the burner head
and burner cap before
starting this procedure.
Then:
1. Remove the injector
inside the top burner with
a suitable bit. Later, install
the new injector by covering
the injector threads
with leakage
preventing
^ “ device
material.
spark plug
In models with Removal of the control panel
Jlecfucetf Tup Flow
In models with removal of the
control panel
h Open the front door.
2. Unscrew the two screws of the control
panel and take the control panel bottom
sheet.
3. Release the control panel from the two
notches at the top, slightly pull it to the
bottom front and keep it free with its cables
connected.
Ignite Hie burner that should be adjusted,
turn the knob to the reduced position, pull
and take the knob off.
4. With a screwdriver, make the tap
reduced flow adjustment from the injector
that is on the gas tap (only the head is
visible with the bolt shape}.
If is sufficient to tight to screw
completely, in butane/propane gas.
For the natural gas, you should turn the
screw counter-clockwise
once. The normal length of a straight
flame in the reduced position
i1i1i1i1i1if i1i1i1i1!i!i!i!i!i!i
■ :i :i r :i :i :i :i:::::::::::;
:::::
:::::
:i:i:i:i :ii sJi Ji:i:i:::::is is is 5
:i i- : :i ji :i:::::::::::;
■ ^ VX; r ■ r.. ■ A
1 - . .'1
should be 6 - 7mm.
If the flame is higher than the desired
position, turn the screw clockwise. If its
smaller to the opposite.
For the last control of the burning of the
cooker, bring the cooker high-flame and
reduced positions and check whether the
flame is on or off.
16