Oven interior, Catalytic-enamelled models(if available), Do not use dry powder agents for cleaning – Инструкция по эксплуатации Beko CE 66200
Страница 53: Warning, If your oven obtains steel rack, Oven door, Lowering the heating element
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Oven interior
Before switching on again ensure that all controls are
in the OFF position. Take out all trays and the grill out
of the oven. Clean out the interior with a piece of moist,
soapy cloth. Then, clean it once more with a wet piece
of cloth and let it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may be
used after carefully reading the warning that are written
on the labels.
Warning!
Never clean the inside of the oven and trays with hard
brushes, steel pads or knives.
Special cleaners that are commercially avaible may be
used after carefully reading the warning that are written
on the labels.
* Catalytic-enamelled models(if available);
The
oven
interior
of
this
model
is
coated
with
catalytic
enamel
since
the
catalytic
enamel
cleans
itsellf,
you
do
not
have
to
perform
an
extra
cleaning
after
the
cooking
operation.
If your oven obtains steel
rack;
To clean the steel rack,
unscrew the 4 screws. After
cleaning operation, assemble
the steel rack to the oven body
again.
Oven door
W ipe over the door outer panel with a cloth wrung out in hot soapy water,
then after wiping with a
cloth wrung out in clear water. Do not use scouring pads or abrasive powder
which may scratch the surface. Take care during cleaning not to damage or
distort the door seal.
Lowering the heating element
(
if
available
)
Warning!
Make sure that the heating element
is sufficiently cool before you start
cleaning.
1.
Unlock the heating elementby
turning the screw at the seiling of the
oven cavity.
Warning!
Never
switch
on
the
heating
element
or
place
any
wright
on
it
when
the
heating
element is in the lowered position.
2.
After cleaning, move the heating
element upward and screw it to the
ceiling of the oven cavity.
24