Beko CE 66200 - Инструкция (Страница 37)

4.2 Operating the hot plates
p r o t e c t o r
I f y o u r h o b h a s ' O v e r h e a t p r o t e c t i o n '
H o t p l a t e s t h a t h a v e p o w e r b i g g e r t h a n 1 0 0 0 W , h a v e
h e a t p r o t e c t o r i n s i d e
The thermal protector reduces the power, if excessive heat is
detected during abnormal operating conditions.
Diameter of pot * Max. concavity * Max. concavity
bottom in cold condition in hot condition
145 mm 0.9 mm 0.5 mm
180 mm 1.1 mm 0.6 mm
Abnormal operating conditions are
- When there is not any pot or saucepan on hotplate
- When all the water in pan or saucepan has evaporated.
- When there is excess boiling
- If bottom of pot is not smooth flat (i.e. if it is concave or convex)
• If one cooks meal with cold water, abnormal condition will end.
In this case hotplate will run in full power.
Corresponding Cooking Values
Hotplate control positio 1 1 2 1 3 4 1 5 1 6
Application Warming Simmering Cooking-Frying-Boiling
A rapid heating hotplate is denoted by a red spot in the centre of
the hotplate:
Hotplate operating knobs
The knobs for the hob can be rotated in either direction to provide
fully variable heat control. When any one of the hotplates is on, the
red indicator light on the control panel will be on.
In order to switch the hotplate OFF turn the corresponding knob to
the 0 (zero) position. Knobs of the hotplates can be turned both
clockwise and counter-clockwise directions.
Check that all the cooker controls have been switched off after
use.
Adjust the hotplates to mid position (3) and leave on for approximately
8 minutes in order to burn off the protective coating on the hotplates.
Do not place any pans or other cooking utensil on the hotplates
during this process. Fumes will be emitted during the above operation
but this is quite normal.