Select, Volume, Enter – Инструкция по эксплуатации Panasonic SC-DT310
Страница 62: Fm mode, Tuner, For southeast asia, Automatic presetting, Manual presetting, The radio
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
The radio
SELECT
VOLUME
r v
A, ▼, ◄,
ENTER -
FM MODE-
TUNER
SLOW/SEARCH
-----►►
VOLUME
-------- +
Manual tuning
Press [TUNER] to select
“AM”.
‘FM” or
Press [◄◄] or [►►] to select the
frequency of the required station.
TUNED: Displayed when a radio station
tuned
’«
is tuned.
ST: Displayed when a stereo FM broadcast
is being received.
Press and hold [◄◄] or [►►] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a
station is found.
3
Adjust the volume.
■ If noise is excessive in FM
Press [FM MODE] to display “MONO”
FM 87.50
Press [FM MODE] again to cancel the mode.
The mode is also canceled when you change the frequency.
For Southeast Asia
■ AM frequency step |
Main unit only
The step is factory-set to 9 kHz, but you can change it to receive
broadcasts allocated 10 kHz steps.
1 Press [SELECT] to select “AM”.
2 Press and hold [SELECT].
After a few seconds fhe display changes to show the current
minimum frequency. Confinue fo hold fhe button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Any AM frequencies presef in channels will be changed by this
procedure. Preset them again.
I
Preset tuning
cn
c
o
Preset channels to make selection simple.
Up to 39 stations can each be set in the FM and AM bands.
2
&
Automatic presetting
o
■ s
1
2
Tune to “FM 87.50” left).
Press and hold [ENTER].
Release the button when “AUTO MEMORY” appears.
The tuner presets all the stations it can receive into the
channels in ascending order.
“SET OK” is displayed when the stations are set. The last
station to be set is then played.
3
4
Tune to “AM 522” (or “AM 520”).
Press and hold [ENTER].
■“ERROR” is displayed
Presetting was unsuccessful. Preset manually.
Manual presetting
1
2
Tune to the station left).
Press [ENTER].
ME-CH-
3
4
Press
[ A , T ]
to select a channel.
Press [ENTER].
The station occupying a channel is erased if another station is preset
in that channel.