Sven HT-500 - Инструкция (Страница 22)

USER’S MANUAL
22
For PCM signal delay time adjustment is as follows:
• Press the R-DLY on the remote controller, RL&RR indicator will light up.
• Press the R-DLY + or R-DLY - to adjust the required delay time.
Remark:
The delay time range of Dolby Digital 5.1 The delay time range of PCM
1. Centerchannel delay: 0–5 ms
Rear channel delay: 15–30 ms
2. Rear channel delay: 0–15 ms
Testing Channel Connection
Set up the system in 5.1 mode first, then press the TEST button. A Pink noise will appear alternatively in the sequence
of FR-C-FL-RR-RL-SW.
• If no sound or queer noise is heard in a particular channel during the test, double check the wiring or VOL- button.
• During the test you may adjust the level of various channel using the VOL+ or VOL- button.
• To cancel the test, press the TEST button again.
Remark:
• The subwoofer of this system is always on, and can not be turned off.
• When a certain channel is under test, the corresponding indicator will blink.
Adjusting Dynamics Range
You may choose a dynamic range by pressing the DR button on the remote controller. There are four setting choices:
0%, 25%, 50%, 75% and 100%.
Listen
• When the signal is DTS or Dolby Digital, Press the LISTEN button on the remote controller to select 2.1CH or 5.1CH
(STEREO) effect.
• When the signal is PCM, Press the LISTEN button to select 2.1 CH 5.1CH (STEREO), PL II M USIC or PL II MOVIE.