Vitek VT-6405 - Инструкция (Страница 6)

English
6
light, rain or snow does not get it.
House mechanisms (door bell, signal
system etc.) can cause interferences
while reception by the base unit of
data signals from the remote sensor.
It is normal and does not influence the
general operation. Transfer and re-
ception of the data signal will resume
immediately after the temporary inter-
ferences disappear.
Placing batteries in the remote
sensor
1. Unscrew the screws on the
battery compartment lid.
. Select data transfer channel
using the channel switch.
. Set  batteries, following the
polarity.
. Close the battery compartment
lid and tighten up the screws.
Connecting the net adapter to the
base unit/placing batteries into
the base unit
1. Open the battery compartment
lid.
. Set  batteries (“ААА”, 1.5 V),
following the polarity.
. Close the battery compartment
lid and tighten up the screws
. Make sure that the adapter
voltage corresponds to the
voltage in the mains.
5. Using the external power supply
jack, connect the net adapter to
the base unit supplied (7,5
V DC) .
Note:
The base unit is intended to be pow-
ered by the external power supply;
battery supply is a backup variant.
If the net adapter is disconnected
from the base unit, the following sym-
bol will appear on the display ( )
Battery replacement
When the corresponding indication
about battery discharge appears you
should replace the batteries.
Note: While long operation of the
remote sensor at high or low tempera-
tures, its voltage can lower, reducing
thus the operating radius of its trans-
mitter.
STARTING OPERATION
After inserting of the batteries in the
remote control, it will start data trans-
fer (temperature and humidity) with
about 5 second intervals. In about
two minutes after inserting of the
batteries in the base unit or connect-
ing to the mains, it will start in its turn
searching of a signal from the remote
control. In ten minutes after receiving
data, they will appear on the display of
the base unit. Data updating is per-
formed automatically in 5 seconds.
If there is no signal from the remote
sensor, the “--“symbols will appear on
the display.
For synchronization of the base unit
and the remote sensor press and
hold the
▼/SEARCH button during 
seconds.
Note: Repeat this procedure, if the
registrations of the remote sensor dif-
fer from those of the base unit.
6405IM.indd 6 12.11.2008 11:21:13