Vitek VT-6405 - Инструкция (Страница 5)

English
5
DESCRIPTION
Basic unit (pic.1)
1. Display
. The SNOOZE
button - Switching
on the LCD-display signal and
backlight repeat function
, 5. the +/- buttons - Value changing
of the entering characteristic
. The MODE button – switching
between display sectors,
confirmation of the value
6,8. The AL1, AL buttons - Displaying
of alarm actuation, alarm
switching on/off
7. The °С/°F buttons - Switching of
temperature units
9. Hole for fastening of the unit on
the wall
10. The CHANNEL button - Switching
of channels importing data from
remote sensors
11. The ▼/SEARCH button -
Searching a signal from the
remote sensor
1. The UNIT button - Selecting
pressure measuring units
1. The ▲/MEMORY button -
Displaying of maximal/minimal
temperature values registered
by the basic unit and the remote
sensor
1. The PRESSURE/ALTITUDE button
– Displaying of pressure/altitude
values and entering the setup
mode
15. The RESET button
16. Battery compartment lid (
for 
batteries “АА”)
17. Table support
18. Net adapter jack (DC7,5 V)
Remote temperature sensor (pic.2)
L. LED on Front Panel
When device is transferring data,
LED blinks one time.
When battery replacement is
required, LED blinks two times.
M. Battery Compartment
Compartment is intended for 
batteries of UM- or АА type.
N. Reset Button (RESET)
This button is used to reset
sensor after changing channel
number.
O. Button for switching between
Celsius/Fahrenheit scale
P. Channels switch (CHANNEL)
This button is used for selecting
channel of data transfer before
batteries installation.
Q. Hole for Mounting Device to Wall
BEFORE OPERATION
For proper operation of the unit insert
the batteries firstly into the battery
compartment and then into the base
unit. Set the remote sensor within
effective data transfer radius, and as
close as possible to the base unit.
Place the based unit and the remote
sensor in places with minimal interfer-
ences for better data transfer.
Take
into consideration, that the data
transfer radius depends on the con-
struction material of partitions of the
building and its quantity. Try out sev-
eral variants of the remote sensor and
base unit allocation. In spite of the
fact that the remote sensor is protect-
ed from meteorological conditions, it
should be set in a way that direct sun-
6405IM.indd 5 12.11.2008 11:21:12