Hyundai H-CMD4031 - Инструкция (Страница 12)

12 13
Operation Operation
VOL- buttons on the RC or rotate VOLUME
regulator on the panel to select between BEEP
ON (beep sound will be heard when buttons
are pressed) and BEEP OFF. After you have
reached your desired effect, leave the unit idle
in order for the new setting to take effect.
Button backlight color
Press repeatedly SELECT button on the
panel or SEL button on the RC until the display
shows COLOR1 (COLOR2). Press VOL+/VOL-
buttons on the RC or rotate VOLUME regulator
on the panel to select between COLOR1
(green button backlight) and COLOR2 (red
button backlight). After you have reached your
desired effect, leave the unit idle in order for
the new setting to take effect.
TFT on/off
Press POWER/TFT OFF button on the panel
to switch the TFT display off. Press the button
again to switch the display on.
AUX in jack
AUX-in jack is intended for connecting
external audio equipment to amplify the
sound. If connection is made correctly, the
audio signal from the external source will be
translated through the acoustics of the head
unit. This enables to adjust the volume and
quality of the sounding. For example, you can
connect an MP3-player to listen to tracks using
the car acoustic system.
Radio operations
Band select
Press repeatedly BND/NP button on the
panel or BAND button on the RC to select your
desired radio band in Radio mode: FM1, FM2,
FM3, AM1 (MW1), AM2 (MW2). In each set of
the bands you can store up to 6 preset stations,
making total 30 preset memory stations.
Auto/Manual tuning
• Manual tuning: Press PREVIOUS/NEXT
buttons on the panel or on the RC to manually
adjust the radio frequency.
• Auto tuning: Press and hold PREVIOUS/
NEXT buttons on the panel or on the RC, the
radio will seek to the next up or down strong
and clear frequency station automatically.
Repeat this action to seek for other desired
stations. To stop automatic search, press NEXT
or PREVIOUS button on the panel or on the RC.
Programming tuner stations
There are six numbered preset buttons,
under which you can store and recall stations
for each band. Select the needed frequency,
then press and hold a preset button. The
station will be saved in the memory under
the corresponding number. To recall a stored
station, press the corresponding preset button.
Automatic store/preset scan
• Automatic store: Press and hold AUDIO
TYPE/APS button on the panel or AMS button
on the RC. SCAN ON will be displayed. The
radio will automatically store the 6 strongest
available stations to the 6 preset memories of
the current band. To stop auto store, press this
button again.
• Preset scan: Press AUDIO TYPE/APS
button on the panel or AMS button on the RC.
INTRO ON will be displayed. The receiver
will scan the saved stations in all bands for 5
seconds.
Mono/Stereo control (in FM radio mode)
Press repeatedly SELECT button on the
panel or SEL button on the RC until the
display shows ST ON (ST OFF). Press VOL+/
VOL- buttons on the RC or rotate VOLUME
regulator on the panel to select between ST
ON/OFF. ST ON means stereo reception of
the signal; ST OFF means mono reception
mode. Or press STEREO button on the RC to
switch stereo reception on/off. Improvement
of reception of distant stations can be done