Removable timer operating the timer, Care and cleaning, Replacing the timer battery – Инструкция по эксплуатации Kenwood DF420
Страница 7: Service and customer care
removable timer
operating the timer
1 Press the button once, the display will show “00”.
2 Press again to set the countdown time in 1 minute
intervals. Hold the button in until the required set time is
reached ie “05” = 5 minutes. Then release the button.
Note: The timer will only display seconds when the
countdown time is below 1 minute.
3 The display will flash until the time reaches “00”
4 To change the countdown time during operation, press
and hold the button in for 3 seconds. The display will
reset to “00” and a new time can be set.
5 When the countdown has finished the timer will “beep”
for 10 seconds. To stop the timer beeping, press the
button once.
6 The display will automatically turn off after 45 seconds
if not in use.
care and cleaning
●
Never start cleaning until the oil has cooled
down.
●
Always unplug before cleaning.
●
Pour the oil out of the bowl using the pouring lip on the
rim of the bowl
ቧ.
●
Ensure everything’s completely dry before
reassembling.
lid
●
Remove and soak in hot soapy water for 20 minutes.
basket
●
After each use, remove and soak in hot soapy water for
20 minutes. Then use a stiff brush.
fryer body/fixed bowl
●
Fryer outer body - wipe with a damp cloth and dry.
Never put it in water.
●
Inner bowl - fill with hot soapy water and soak for 20
minutes. Then use a non-abrasive cleaner.
●
The lid and basket can be washed in the dishwasher.
replacing the timer battery
1 Unclip the front cover
.
2 Lift out the display unit
.
3 Open the display unit by squeezing the clips
together .
4 Replace the battery - type L1154 or equivalent from
your local electrical retailer or chemist. Fit the new
battery ensuring it is the correct way round.
5 Shut the display unit and replace in the timer body.
6 Refit the timer button
and the front cover.
●
The old battery should be disposed of in accordance
with local recycling recommendations.
service and customer care
●
If the cord is damaged it must, for safety reasons, be
replaced by Kenwood or an authorised Kenwood
repairer.
●
If you experience any problems with the
operation of the fryer, before calling for
assistance refer to the troubleshooting guide.
If you need help with:
●
using your fryer or
●
servicing or repairs
●
Contact the shop where you bought your fryer.
4