Yamaha RX-V365 - Инструкция (Страница 46)

42
En
Troubleshooting
After AUTO SETUP
Notes
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “PHASE REVERSED” appears, corrections are made, but they may not be optimal.
• If a warning message “DISTANCE ERROR” or “LEVEL ERROR” appears, no corrections are made.
■ Remote control
■ Resetting the system
Use this feature to reset all the parameters of this unit to the initial factory settings. For details about the procedure of
resetting the system, see “Initializing” in “Advanced setup” on page 37.
Warning message Cause Remedy
See
page
PHASE REVERSED Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper polarity (+
or –).
9
DISTANCE ERROR The distance between the nearest speaker
and the furthest speaker is out of
adjustable range.
Bring the speaker closer to the listening position. —
LEVEL ERROR The difference of volume level among
speakers is excessive. (No level correction
is made.)
If “SWFR:TOO LOUD” or “SWFR:TOO LOW”
appears, adjust the output volume of the subwoofer.
16
Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
—
Check the speaker connections. 9
Use speakers of similar quality. —
Problem Cause Remedy
See
page
The remote control
does not work nor
function properly.
Wrong distance or angle. The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
8
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit. —
The batteries are weak. Replace all batteries. 8
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.