Petsafe Magnetic 4-Way Locking Cat Flap - Инструкция (Страница 44)

44
www.petsafe.net
FI
SV
DA
NO
RU
EN
Before installing your cat flap
please read the following step-by-
step instructions carefully.
Tools required
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 5 mm ( 3 /
16
”) drill bit
• Screwdriver
• Tape measure
• Glue
• Sand paper
Measurement and marking
Measure the belly height of your cat. This is usually 100 mm to
150 mm ( Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 168 mm ( Fig. 2).
Usually this line will be the bottom of the hole you cut in your door – the
frame of the cat flap will be slightly lower. With Magnetic cat flaps it is
important that the cat is able to approach the cat flap without obstacle.
There should be a level area in front of the cat flap outside which is
sufficient for the cat to stand with all four paws on the same level.
FIG.1 FIG.2
Cutting a hole for your cat flap
a) In Wood
The cat flap requires a square cut-out of 175 mm x 168 mm ( Fig. 3).
Not to scale - for best results you should refer
to the enclosed cutting template.
(x)
(x)
168 mm
175 mm
FIG.3
Wooden doors