Vitek VT-3970 Y - Инструкция (Страница 8)

ENGLISH
8
Notice: Settings should meet the slot you
choose to connect a player to auxiliary device.
Power connection
Mains power supply
Make sure mains supply voltage meets operat-
ing voltage of the appliance before connecting
to mains supply.
Insert patch plug of power cord into AC IN slot,
and insert plug into a wall outlet. If operating
mode switch is in OFF position, standby mode
indicator (STANBY) is lighted. After switching
to radio (RADIO) or DVD mode, LCD is on and
STANDBY indicator is off.
Notice: Static electricity could cause clutter dur-
ing operation. In this case, disconnect the ap-
pliance from power source, and connect it back
after some time. If problem cannot be solved
thus, apply to nearest service center.
Battery power supply
. Disconnect player from mains supply.
2. Open battery compartment cover located
on player back by pressing on two latches in
direction indicated by arrow.
3. Insert eight batteries of D /UM- type (2V)
into battery compartment.
. Close battery compartment cover.
Notice: In standby mode, the appliance still
needs power. To switch the appliance complete-
ly unplug power cord and extract batteries out of
battery compartment.
DVD/CD/MP3/VCD/SVCD playback
. Set operating mode switch into «DVD»
position.
2. Open disk compartment by pressing
OPEN/CLOSE button. At this, mark “LOAD”
appears in LCD, and disk playback starts.
3. Set volume level you need using VOLUME
control.
. Press PLAY/PAUSE button to pause
playback. To resume playback press this
button once more.
. Press button STOP once during disk
playback to make your player remember the
point of stop. Press button STOP second
time to stop playback completely.
. To repeat current track once press button
REPEAT once during disk playback. At this
mark “rP ONE” appears on LCD.
To repeat all tracks press button REPEAT
twice during disk playback. At this mark “rP
ALL” appears on LCD.
7. To cancel repeat mode press button
REPEAT trice during disk playback. At this
mark “rP OFF” appears on LCD.
If your disk contains several folders, press but-
ton REPEAT twice to repeat current folder, at
this mark “rP Dir” appears on LCD. To repeat all
tracks press this button trice. Press this button
four times to cancel repeat mode.
Using USB appliance/memory cards
. Set operating mode switch into «DVD»
position.
2. Insert USB appliance or memory card into
corresponding slot.
3. Press button DVD/USB/CARD located on
player control panel or on Remote Control,
and select one of following media types:
disk, USB appliance or memory card.
Appliance starts reading disk, afterwards
playback of selected device is started
automatically.
. To stop playback press button STOP on
player of remote control and detach panel.
Notice: Function DVD/USB/CARD is
available only f disk compartment cover is
closed.
In DVD/USB/CARD mode menu is displayed
on TV-set screen.
Do not detach panel during playback.
Listening radio
. Set operating mode switch into «RADIO»
position.
Select band you need: FM, AM or FM ST (FM
stereo) by setting frequency range switch
into corresponding position. In FM range
extend antenna as much as possible and
find correct direction to provide better
reception.
2. Select station you need by rotating radio
stations tuning knob (TUNING).
3. Use volume control (VOLUME) to adjust
volume level.
. Set mode switch to “OFF” position if you
have finished listening radio.
. “STEREO” marks appear on the LCD while
tuning to transmitting station.
Karaoke function
. Connect microphone to corresponding slot
and switch player to CD/VCD or DVD mode.
3970IM.indd 8 18.06.2008 10:29:26