Vitek VT-3951 B - Инструкция (Страница 6)

ENGLISH
6
for better reception in AM band, try several
variants of the cassette recorder location.
5. After you finish listening to the radio set the
operating mode switch to OFF position or
select another operating mode.
BASS
For low frequency amplification press the BASS
button, the corresponding indication will light
up. To switch off low frequency amplification
press this button once again, the indication will
go out.
Cassette playback
. Set the operating mode switch to the TAPE
position.
2. Press the STOP/EJ button and insert a cas-
sette into the cassette compartment.
. Close the cassette compartment.
. Press the PLAY button to playback.
5. Use the corresponding knob to adjust vol-
ume level.
6. Use the PAUSE button to pause playback.
7. Press the STOP/EJ button to stop playback.
8. To fast forward/fast rewind use the F.FWD/
REW buttons correspondingly.
9. After the playback is finished, it will stop
automatically.
0. Press the STOP/EJ button to eject the cas-
sette, eject the cassette from the cassette
compartment.
Warning! In order to avoid damaging of the
cassette mechanism or the tape always press
the STOP/EJ button after each operation.
Recording
General information
You can record on the cassette, in case that you
do not violate the rights of third parties.
You cannot use for record the following cas-
sette types: СHROME (IEC II) or METAL (IV), use
NORMAL (IEC I), that have record locking.
To protect the recording, remove the cor-
responding locking, so it will be impossible to
write over this recording. To write the recording
over close the hole with the isolating tape. At
the very beginning and at the end of the cas-
sette there is no recording for 7 seconds.
Recording from the radio
. Tune to the desired radio station, following
the instructions in “Radio station reception”.
2. Insert a blank cassette in the cassette com-
partment.
. Press the RECORD button, the PLAY button
will be pressed automatically. You can adjust
the volume level, without being afraid to
make the record quality worse.
. To stop the recording temporary press the
PAUSE button. To resume recording press
this button again.
5. Press the STOP/EJ button to stop recording.
Recording from CD
You can record from a CD disc.
. Insert a blank cassette in the cassette com-
partment.
2. Select the corresponding operating mode.
. Open the disc compartment, by pressing
the OPEN/CLOSE button. Place a CD disc
and close the disc compartment lid. Select a
track you want to record.
. Press the PLAY/PAUSE button to playback
the selected track.
5. Press the RECORD button, the PLAY button
will be pressed automatically. You can adjust
volume level, without being afraid to make
the record quality worse.
6. To stop recording temporary press the
PAUSE button. To resume recording press
this button again.
7. Press the STOP/EJ button to stop recording.
Cleaning the cassette deck
To provide for a good playback quality and re-
cording, you should wipe А, В and С elements
from time to time after 50 hours of operation,
use a cotton cloth dampened in alcohol or spe-
cial liquid.
3951IM.indd 6 19.05.2008 15:20:30