Vitek VT-3951 B - Инструкция (Страница 5)

ENGLISH
5
Remote control
27. The PROGRAM button
28. The track/folder button: -0/FOL- +0/FOL+
29. The PLAY/PAUSE (
►║) /USB button
0. The BACK track button / fast rewind /
. The NEXT track button/fast forward /
2. The STOP button
. The REPEAT/RANDOM button
. Volume control (is inactive in the radio mode
and cassette playback mode)
Before operating
Unpack the unit. Remove the stickers from the
upper and front panel.
Attention! Do not remove the stickers, concern-
ing safety, on the rear panel!
Press the CLOSE/OPEN button and remove the
protective insert before operating the unit.
POWER CONNECTION
Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the
voltage specified on the unit.
. To connect the unit, insert the plug of the
power cord in the corresponding jack (2).
Set the switch () in the desired operating
mode.
Note: Static electricity can lead to interferences
in the operation of the unit. In this case
disconnect the unit, and then connect
again. If the problem does not disappear,
apply to a service center.
2. To switch off the unit completely, disconnect
the power cord from the power supply.
Note: Static electricity can lead to interferences
in the operation of the unit. In this case
disconnect the unit, and then connect again.
If the problem does not disappear, apply to a
service center.
Battery supply
. Disconnect the cassette recorder.
2. Open the main battery compartment lid
() on the rear of the unit, by pressing the
catch.
. Insert 8 UM-2/R / C batteries (not sup-
plied) in the battery compartment following
the polarity.
. Close the battery compartment lid ().
USING THE REMOTE CONTROL
Insert 2 АAA batteries (not supplied) in the bat-
tery compartment of the remote control.
When using the remote control direct it to the
infrared SENSOR on the cassette recorder. The
effective distance of the remote control opera-
tion is about 5 meters, in case of its operating
distance reduction, check the batteries and
replace them if necessary.
The functions of the buttons on the remote
control are the same as those of the buttons on
the cassette recorder.
Do not expose the remote control to high
temperature or direct sunlight; it can negatively
affect the operation of the unit.
Attention!
Battery leakage can lead to injuries and
damages of the unit. To avoid it follow the
instructions below:
- Place the batteries properly, following the
polarity marked inside the unit.
- Do not use old and new batteries or
batteries of different types together.
- Take the batteries out if you are not going to
use the unit for a long time.
BASIC FUNCTIONS
. Select operating mode using the switch ():
AUX (MP), TAPE (OFF), RADIO.
2. Use the volume knob to set the desired
volume level ().
. After using the unit set the switch to OFF
position.
Attention! In order to save energy always set
the operating mode switch to OFF position,
when you are not using the unit.
Radio stations reception
. Set the operating mode switch to RADIO
position.
2. Select the desired range: FM, AM or FM ST
(FM stereo), by setting the range switch to
the corresponding position.
While tuning to a station, transferring stereo
signal, the FM ST indication will light up.
. Rotate the TUNING knob to select the
desired radio station.
. For better reception in FM band extend
the aerial completely and place it at the
desired angle. For reception in AM band the
cassette recorder has a built-in antenna,
3951IM.indd 5 19.05.2008 15:20:30