Pioneer AVIC-F220 - Инструкция (Страница 16)

After installing this
navigation system
CAUTION
After installing this navigation system, be
sure to check at a safe place that the vehicle
is performing normally.
It may take a few minutes to start up the navi-
gation system when you start up the system
for the first time or the outside temperature is
not within the charging range. Wait until the
battery charging starts.
1 Reconnect the negative (
–) terminal of
the vehicle
’s battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (
–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Press the RESET button.
Press the RESET button on the navigation unit
with a pointed object such as the tip of a pen.
RESET button
After a short pause, the navigation screen re-
turns.
p If the navigation screen does not return
after a while, press the MODE button of the
AV receiver to switch the screen.
4 Make the following settings.
= For details concerning operations, refer to
Operation Manual.
1 Set the language.
2 Drive an unobstructed road until the GPS
starts receiving the signal normally.
3 Make some necessary adjustments.
! Setting the time
! Change other settings as you prefer
Engb
16
Section
05 After installation