Binatone SI-5000 - Инструкция (Страница 7)

7
ENGLISH
Attention: The «Drip Stop» system automatically
terminates the steam generation process if the selected
temperature is too low. When the system is activated,
you may hear a click.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles
turn the Select Knob (7) to the position « », then press the Select
Knob (7) for an extra blast of steam: engagement of the button
during the ironing process generates an extra burst of steam from
the sole plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to fresh the appearance of curtains, jackets,
coats, etc. To use this function, take the following steps:
! Follow instructions in paragraph 1-5 of the section «Instruc-
tions for use». While selecting the temperature setting, turn
the Select Knob (7) to the position « ».
! While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the Select Knob (7)
to produce a directional strong burst of steam from the sole
plate. Push the button several times with 5-7 seconds intervals
until the article is fully refreshed. If during the process your
water tank (5) runs out of water, disconnect the appliance from
the mains outlet, refill the tank and plug the appliance back
into the power supply and continue the process.
Spray
Turning the Select Knob (7) to the position water spray « »
will help when ironing details of the article (cuffs, trimmings, plackets,
etc) or clothes, which demand low temperature ironing, when steam
ironing is not possible. Push the Select knob (7) several times to
moisten the material.
Self-Cleaning
Your iron has a self-cleaning function, which allows you to clean
the internal parts of the appliance from scale or dust. To use this
function perform the following procedure:
1. Turn the Select knob (7) to the position «
».
2. Fill the tank (5) with water to the «Max» level.
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the Fabric Setting indication (9) to «ËÅÍ» position (see Fig-
ure B) and let iron heat until indicator light (10) stops blinking.
5. When the iron reaches the maximum temperature, the indica-
tor light (10) will stop blinking. Set Fabric Setting indication
(9) to «РЕЖИМЫ» and «
» position.
6. Whilst holding the appliance horizontally over a sink, turn the
Select Knob (7) to the «SELF-CLEAN» position. Hot steam will
discharge from the sole plate (11) removing the scale and dust.
7. If the blast of steam becomes weaker, repeat steps 4-6 several
time. When the water tank (5) is completely empty, turn the
Select knob (7) to the position «
».
8. Put the appliance into a vertical position and re-heat the iron.