Hyundai H-CCR8187M - Инструкция (Страница 10)

Operation
10
General operations
Turning the unit on/off
Press /TFT OFF button on the
panel or button on the RC to turn
the unit on. Press and hold the button
to turn the unit off.
Reset the unit
Operating the unit for the first time
or after replacing the car battery, you
must reset the unit. Press RESET
button (hole) with a pointed object
(such as a ballpoint pen) to set the
unit to initial state.
When some errors occur,
you can also press RESET button to
resume to normal, and it will erase
clock setting and some memorized
functions.
TFT display on/off
When the unit is on, press /TFT
OFF button on the panel to switch off
the display. When the display is off,
the video out signal will be available
so that the connected monitor will
show the screen of the unit. Press this
button again to resume the image.
Mode selection
• Press repeatedly MOD button
on the panel or MODE button on the
RC to select between Radio, USB,
Memory Card and auxiliary input
(AUX), operation modes. Modes of
operation are indicated on the display.
Memory card and USB modes are not
available unless a memory card or
USB device is connected.
• Or, in radio or AUX modes, press
button on the panel or button on
the RC to display the main menu. In
the menu select an operation mode by
rotating VOLUME knob on the panel
or pressing UP/DOWN cursor buttons
on the RC, then press OK button on
the RC or SELECT button on the
panel to confirm selection.
Volume control
Adjust volume by rotating VOLUME
knob on the panel or pressing V+/V-
buttons on the RC.
Mute function
Press MUTE button on the panel
or on the RC to switch off the sound;
press it again or adjust volume to
resume the sound.
Audio parameter setting
Press SELECT button on the panel
or SEL button on the RC repeatedly
to select a parameter: VOL (volume)
=> BAS (bass) => TRE (treble) =>
BAL (balance) => FAD (fader) => EQ
(equalizer) => Beep => Loud ON/OFF.
Rotate VOLUME knob on the panel or
pressing V+/V- buttons on the RC to
adjust each mode:
• Volume: from 0 to 39;
• Bass/Treble: from -7 to 7;
• Balance: L7 (left) to R7 (right);
• Fader: from R7 (rear) to F7 (front);
• EQ: select OFF/ROCK/POP/
CLASS equalizer mode;
• Beep on: the beep sound is heard
when a button is pressed; beep off:
the sound is not heard;
• Loudness: select ON or OFF.
Activating this feature will enhance
bass and treble frequencies when
listening to music at low volumes.
When equalizer is in any mode